Switch>enable 进入特权模式
Switch#config 进入配置模式
Configuring from terminal, memory, or network [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#vlan 100 创建vlan 100
Switch(config-vlan)#exit 返回
Switch(config)#int range fa0/1-10 进入1-10端口
Switch(config-if-range)#switchport access vlan 100 将端口1-10分到vlan100
Switch(config-if-range)#exit 返回
Switch(config)#vlan 200 创建vlan200
Switch(config-vlan)#exit 返回
Switch(config)#int range fa0/11-23 进入11-23端口
Switch(config-if-range)#switchport access vlan 200 讲端口11-23分到vlan200
Switch(config-if-range)#exit返回
Switch(config)#int fa0/24 进入24号端口
Switch(config-if)#switchport mode trunk 将端口设为trunk模式
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/24, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/24, changed state to up
Switch(config-if)#switchport trunk allowed vlan all 允许所有端口通过该vlan
Switch#
%SYS-5-CONFIG_I: Configured from console by console