RFC destination for client copy in systems with Financials Basis (FINBASIS) component.
Proceed as follows to eliminate this error:
1. Start the wizard to create a new RFC connection
or perform the following steps manually:
1. Create an RFC destination with the target ZK>source client of client
copy (in this case 600).
2. Check whether the RFC destination works in transaction SM59.
To avoid errors when assigning the password or the authorizations of
the RFC user, use the authorization test Test -> Authorization.
3. Enter the RFC destination:
- Transaction: FINB_TR_DEST (Destinations for Transport Methods of
the Financials Basis)
- Client: 600
4. Start the client copy again.
FINBTR@PRDCLNT600
FINB_TR: Generated Destination for Transport Methods
我想把生产机正式生产CLNT 600覆盖到800 CLNT做测试,都是在生产机上,出现以上出错,只要按照提示做就好了。先按向导建立一个800到600的RFC连接,如下图所示:
配置完后保存,测试下连接情况:
测试通过后,执行T-CODE:FINB_TR_DEST, 把FIN Compontent的Destination设置好,如下图:
一定要注意好Client是源Client!加好之后,保存。继续执行SCC4,会发现可以正常安排CLNT COPY了。最后安排的后台作业如下:
Okay,Done!
From:http://blog.csdn.net/jamesxsy/article/details/3998569