vmware虚拟机怎样让linux（centos6.4）桥接上网|本机用putty连接centos通信

一、vmware的网卡连接方式选择为桥接（bridged）不要用Nat方法，如下图所示：





二、修改虚拟机centos上的网卡配置    /etc/sysconfig/network-scripts/ifcfg-eth0

[root@localhost tomener]# vim /etc/sysconfig/network-scripts/ifcfg-eth0

DEVICE=eth0
HWADDR=00:0C:29:45:97:65
TYPE=Ethernet
UUID=18d76aa8-6142-45fa-98dd-4e0d391fc90c
ONBOOT=yes
NM_CONTROLLED=yes
BOOTPROTO=static

NETMASK=255.255.255.0
IPADDR=192.168.1.200
GATEWAY=192.168.1.1
DNS1=8.8.8.8

提示：BOOTPROTO的设置，可以设置为static 或者 dhcp

三、禁止掉SELINUX

[root@localhost tomener]# vim /etc/selinux/config


# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
#     enforcing - SELinux security policy is enforced.
#     permissive - SELinux prints warnings instead of enforcing.
#     disabled - No SELinux policy is loaded.
#SELINUX=enforcing
SELINUX=disabled
# SELINUXTYPE= can take one of these two values:
#     targeted - Targeted processes are protected,
#     mls - Multi Level Security protection.
SELINUXTYPE=targeted


这里是把SELINUX=enforcing 改为 SELINUX=disabled

第四步：重启network
service network restart

第五步：ping www.baidu.com

[root@localhost tomener]# ping www.baidu.com
PING www.a.shifen.com (115.239.210.26) 56(84) bytes of data.
64 bytes from 115.239.210.26: icmp_seq=1 ttl=55 time=204 ms
64 bytes from 115.239.210.26: icmp_seq=2 ttl=55 time=119 ms
64 bytes from 115.239.210.26: icmp_seq=3 ttl=55 time=264 ms
64 bytes from 115.239.210.26: icmp_seq=4 ttl=55 time=207 ms
^C


到此，让在vmware虚拟机上的centos上网，并起和本机通信就完成了，

现在你就可以是用putty来连接了你的linux服务器了

如果重启了network还是连接不上，那么先关闭服务器，再启动，不要用重启试试。

参考：http://linux.chinaunix.net/techdoc/beginner/2009/03/23/1102227.shtml