关闭

调整VNC屏幕宽度

1052人阅读 评论(0) 收藏 举报
How can I change the geometry of a VNC Server in Virtual Mode desktop?

You can pass the -geometry option (or any X Server option) directly to the X Server via VNC.

You could do this at the command line to control the geometry of a particular desktop, for example:

vncserver -geometry 800x600

You could create a ~/.vnc/config file and populate it with the following to control the geometry of all desktops created by a particular user:

-geometry 800x600

You could create an /etc/vnc/config.custom file and populate it as above to control the geometry of all desktops created by all users.

Note: If you change a geometry, you must restart VNC Server in Virtual Mode in order for it to take effect.

Alternatively, a connected VNC Viewer user could specify the RandR parameter in the Expert tab of the VNC Server > Options dialog in order to specify a set of geometries:

1024x768,1280x1024,800x600

and then run the command xrandr -s <0|1|2> in order to cycle between them. 

Note: The maximum resolution is controlled by the value assigned to the -geometry X Server option.

0
0

查看评论
* 以上用户言论只代表其个人观点,不代表CSDN网站的观点或立场
    个人资料
    • 访问:188127次
    • 积分:1867
    • 等级:
    • 排名:千里之外
    • 原创:32篇
    • 转载:12篇
    • 译文:0篇
    • 评论:34条
    文章分类
    最新评论