SDIO驱动(11)Host是如何把数据发出去的

Linux 2.6.38
S3C2440

通过“SDIO驱动(10)Host的operations实现”的s3cmci_send_command函数知道了命令的发送方式，接下来分析数据的发送实现。本来吧，无论命令还是数据，它们本质上都是数据，之所以分开说，是因为硬件实现上它们就是独立的，命令和数据分别有自己的寄存器管理、控制。

接着s3cmci_send_request函数分析，18行s3cmci_setup_data：

static int s3cmci_setup_data(struct s3cmci_host *host, struct mmc_data *data)
{
	u32 dcon, imsk, stoptries = 3;

	/* write DCON register */

	if (!data) {
		writel(0, host->base + S3C2410_SDIDCON);
		return 0;
	}

	if ((data->blksz & 3) != 0) {
		/* We cannot deal with unaligned blocks with more than
		 * one block being transfered. */

		if (data->blocks > 1) {
			pr_warning("%s: can't do non-word sized block transfers (blksz %d)\n", __func__, data->blksz);
			return -EINVAL;
		}
	}

	while (readl(host->base + S3C2410_SDIDSTA) &
	       (S3C2410_SDIDSTA_TXDATAON | S3C2410_SDIDSTA_RXDATAON)) {

		dbg(host, dbg_err,
		    "mci_setup_data() transfer stillin progress.\n");

		writel(S3C2410_SDIDCON_STOP, host->base + S3C2410_SDIDCON);
		s3cmci_reset(host);

		if ((stoptries--) == 0) {
			dbg_dumpregs(host, "DRF");
			return -EINVAL;
		}
	}

	dcon  = data->blocks & S3C2410_SDIDCON_BLKNUM_MASK;

	if (s3cmci_host_usedma(host))
		dcon |= S3C2410_SDIDCON_DMAEN;

	if (host->bus_width == MMC_BUS_WIDTH_4)
		dcon |= S3C2410_SDIDCON_WIDEBUS;

	if (!(data->flags & MMC_DATA_STREAM))
		dcon |= S3C2410_SDIDCON_BLOCKMODE;

	if (data->flags & M