网络拓扑图:
选择需要定义MIP的接口,点Edit:
WebUI:
点击MIP,然后点击New,在Mapped IP输入与ethernet1/1接口IP地址同一网段的IP,Host IP输入内网一台服务器IP地址(此处为了测试,就直接输入ISG-1000 ethernet1/2(Trust zone)接口IP),最后按OK保存:
CLI:
set interface "ethernet1/1" mip 211.xxx.xxx.xx host 10.245.32.113 netmask 255.255.255.255 vr "trust-vr"
新建Policy,在Policy中应用MIP,按OK保存:
测试MIP,在PC-A上telnet MIP地址:
由上可知,映射IP地址成功。