ORA-3136错误分析——WARNING Inbound Connection Timed Out

导致这个WARNING出现的主要原因可能是：

1）Server gets a connection request from a malicious(恶意) client which is not supposed to connect to the database , in which case the error thrown is the correct behavior. You can get the client address for which the error was thrown via sqlnet log file. 
2）The server receives a valid client connection request but the client takes a long time to authenticate more than the default 60 seconds. 
3）The DB server is heavily loaded due to which it cannot finish the client logon within the timeout specified. 

那么如何定位导致这个WARNING出现的呢？

The default value of 60 seconds is good enough in most conditions for the database server to authenticate a client connection. If its taking longer period, then its worth checking all the below points before going for the workadound:

1. Check whether local connection on the database server is sucessful & quick.
2. If local connections are quick ,then check for underlying network delay with the help of your network administrator.
3. Check whether your Database performance has degraded by anyway.
4. Check alert log for any critical errors for eg, ORA-600 or ORA-7445 and get them resolved first. 
These critical errors might have triggered the slowness of the database server.

As a workaround to avoid only this warning messages, you can set the parameters SQLNET.INBOUND_CONNECT_TIMEOUT 
and INBOUND_CONNECT_TIMEOUT_<listenername> to the value more than 60.

For e.g 120. So that the client will have more time to provide the authentication information to the database. You may have to further tune these parameter values according to your setup. 

To set these parameter
1. In server side sqlnet.ora file add SQLNET.INBOUND_CONNECT_TIMEOUT 
For e.g 
SQLNET.INBOUND_CONNECT_TIMEOUT = 120 
2. In listener.ora file - INBOUND_CONNECT_TIMEOUT_<listenername> = 110 
For e.g if the listener name is LISTENER then - 
INBOUND_CONNECT_TIMEOUT_LISTENER = 110 

Note:From Oracle version 10.2.0.3 onwards the default value of INBOUND_CONNECT_TIMEOUT_<listenername> is 60 seconds. For previous releases it is zero by default.

How to check whether inbound timout is active for the listener and database server

For eg. INBOUND_CONNECT_TIMEOUT_<listener_name> =4

You can check whether the parameter is active or not by simply doing telnet to the listener port.
$ telnet <database server IP> <listener port>

for eg.
$ telnet 192.168.12.13 1521
The telnet session should disconnect after 4 seconds which indicates that the inbound connection timeout for the listener is active.

To check whether database server sqlnet.inbound_connect_timeout is active: 
Eg. sqlnet.inbound_connect_timeout =5 

a. For Dedicated server setup, enable the support level sqlnet server tracing will show the timeout value as below:

niotns: Enabling CTO, value=5000 (milliseconds) <== 5 seconds niotns: Not enabling dead connection detection. niotns: listener bequeathed shadow coming to life...

b. For shared Server setup, 
$ telnet <database server IP> <dispatcher port>
For eg.
$ telnet 192.168.12.13 51658
The telnet session should disconnect after 5 seconds which indicates that the sqlnet.inbound_connection_timeout is active.

来自 “ ITPUB博客 ” ，链接：http://blog.itpub.net/30393770/viewspace-2125231/，如需转载，请注明出处，否则将追究法律责任。

转载于:http://blog.itpub.net/30393770/viewspace-2125231/