ccna配置一览(转)

ccna配置一览(转)[@more@]

   ccna 试验指导

  启动接口,分配IP地址:

  router>

  router> enable

  router#

  router# configure terminal

  router(config)#

  router(config)# interface Type Port

  router(config-if)# no shutdown

  router(config-if)# ip address IP-Address Subnet-Mask

  router(config-if)# ^z

  

  配置RIP路由协议:30秒更新一次

  router(config)# router rip

  router(config-if)# network Network-Number   router(config-if)# ^z

  

  配置IGRP路由协议:90秒更新一次

  router(config)# router igrp AS-Number   router(config-if)# network Network-Number   router(config-if)# ^z

  

  配置Novell IPX路由协议:Novell RIP 60秒更新一次

  router(config)# ipx routing [node address]

  router(config)# ipx maximum-paths Paths   router(config)# interface Type Port

  router(config-if)# ipx network Network-Number [encapsulation encapsulation-type] [secondary]   router(config-if)# ^z

  

  配置DDR:

  router(config)# dialer-list Group-Number protocol Protocol-Type permit [list ACL-Number]

  router(config)# interface bri 0

  router(config-if)# dialer-group Group-Number

  router(config-if)# dialer map Protocol-Type Next-Hop-Address name Hostname Telphone-Number

  router(config-if)# ^z

  

  配置ISDN:

  router(config)# isdn swith-type Swith-Type   router(config-if)# ^z

  

  配置Frame Relay:

  router(config-if)# encapsulation frame-relay [cisco | ietf ]

  router(config-if)# frame-relay lmi-type [ansi | cisco | q933a ]

  router(config-if)# bandwidth kilobits

  router(config-if)# frame-relay invers-arp [ Protocol ] [dlci ]

    router(config)# frame-relay Protocol Protocol-Address DLCI [ Broadcast ] [ ietf | cisco ] [ payload-compress | packet-by-packet ]

  --&gt

    router(config-if)# keepalive Number

  --&gt

    router(config-if)# frame-lelay local-dlci Number

  --&gt

    router(config-if)# interface Type Port.Subininterface-Number [ multipoint | point-to-point ]

  router(config-subif)# ip unnumbered Interface

  router(config-subif)# frame-lelay local-dlci Number

  --&gt

  router(config-if)# ^z

  

  配置标准ACL:

  router(config)# access-list Access-List-Number [ permit | deny ] source [ source-mask ]   router(config)# interface Type Port

  router(config-if)# ip access-group Access-List-Number [ in | out ]

  router(config-if)# ^z

  

  配置扩展ACL:

  router(config)# access-list Access-List-Number [ permit | deny ] [ Protocol | Protocol-Number ] source source-wildcard [ Source-Port ] destination destination-wildcard [ Destination-Port ] [ established ]

  router(config)# interface Type Port

  router(config-if)# ip access-group Access-List-Number [ in | out ]

  router(config-if)# ^z

  

  配置命名ACL:

  router(config)# ip access-list [ standard | extended ] ACL-Name

  router(config [ std- | ext- ] nacl)# [ permit | deny ] [ IP-Access-List-Test-Conditions ]

  router(config [ std- | ext- ] nacl)# no [ permit | deny ] [ IP-Access-List-Test-Conditions ]

  router(config [ std- | ext- ] nacl)# ^z

  router(config)# interface Type Port

  router(config-if)# ip access-group [ACL-Name | 1~199 ] [ in | out ]

  router(config-if)# ^z

  

  配置DCE时钟:

  router# show controllers Type Port   router(confin-if)# clock rate 64000   router(config-if)# ^z

  

  配置PPP协议:

  router(config)# username Name password Set-Password-Here   router(config)# interface Type Port

  router(config-if)# encapsulation ppp   router(config-if)# ppp outhentication [ chap | chap pap | pap chap | pap ]   router(config-if)# ppp pap sent-username Name password Password   router(config-if)# ^z

  

  PAP单向认证配置实例:

  验证方:

  router-server(config)# username Client password 12345   router-server(config)# interface serial 0

  router-server(config-if)# encapsulation ppp

  router-server(config-if)# ppp authentication pap   router-server(config-if)# ^z

  被验证方:

  router-client(config-if)# encapsulation ppp

  router-client(config-if)# ppp pap sent-username Client password 12345   router-client(config-if)# ^z

  

  PAP双向认证配置实例:

  路由器 A:

  routerA(config)# username B password 12345

  routerA(config)# interface serial 0

  routerA(config-if)# encapsulation ppp

  routerA(config-if)# ppp authentication pap

  routerA(config-if)# ppp pap sent-username A password 54321

  routerA(config-if)# ^z

  路由器 B:

  routerB(config)# username A password 54321

  routerB(config)# interface serial 1

  routerB(config-if)# encapsulation ppp

  routerB(config-if)# ppp authentication pap

  routerB(config-if)# ppp pap sent-username B password 12345

  routerB(config-if)# ^z

  

  CHAP单向认证配置实例:

  验证方:

  router-server(config)# username router-client password 12345

  router-server(config)# interface serial 0

  router-server(config-if)# encapsulation ppp

  router-server(config-if)# ppp authentication chap

  router-server(config-if)# ^z

  被验证方:

  router-client(config-if)# encapsulation ppp

  router-client(config-if)# ppp authentication chap

  router-client(config-if)# ppp chap hostname router-client

  router-client(config-if)# ppp chap password 12345

  router-client(config-if)# ^z

  

  CHAP双向认证配置实例:

  路由器 A:

  routerA(config)# username routerB password 12345

  routerA(config)# interface serial 0

  routerA(config-if)# encapsulation ppp

  routerA(config-if)# ppp authentication chap

  routerA(config-if)# ppp chap hostname routerA

  routerA(config-if)# ppp chap password 54321

  routerA(config-if)# ^z

  路由器 B:

  routerB(config)# username routerA password 54321

  routerB(config)# interface serial 1

  routerB(config-if)# encapsulation ppp

  routerB(config-if)# ppp authentication chap

  routerB(config-if)# ppp chap hostname routerB

  routerB(config-if)# ppp chap password 12345

  routerB(config-if)# ^z

  

  Telnet使用:

  routerA# terminal monitor   routerA# telnet IP-Address [ Router-Name ]   routerB# [ exit | logout ]   routerB# ++<6>再按   routerA# show sessions   routerA# Connect-Number   routerA# disconnect IP-Address [ Router-Name ]   routerA# show user   routerA# clear line [ 0 | 1 | 2 | 3 | 4 ]   

  禁止任何Telnet到本机:

  router(config)# line vty 0 4

  router(config-line)# access-class ACL-Number

  router(config)#


来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/8225414/viewspace-951906/,如需转载,请注明出处,否则将追究法律责任。

转载于:http://blog.itpub.net/8225414/viewspace-951906/

  • 0
    点赞
  • 0
    收藏
    觉得还不错? 一键收藏
  • 0
    评论

“相关推荐”对你有帮助么?

  • 非常没帮助
  • 没帮助
  • 一般
  • 有帮助
  • 非常有帮助
提交
评论
添加红包

请填写红包祝福语或标题

红包个数最小为10个

红包金额最低5元

当前余额3.43前往充值 >
需支付:10.00
成就一亿技术人!
领取后你会自动成为博主和红包主的粉丝 规则
hope_wisdom
发出的红包
实付
使用余额支付
点击重新获取
扫码支付
钱包余额 0

抵扣说明:

1.余额是钱包充值的虚拟货币,按照1:1的比例进行支付金额的抵扣。
2.余额无法直接购买下载,可以购买VIP、付费专栏及课程。

余额充值