Unable to get uboot console on LS1012A freedom board.
Hello,
I am not able to get uboot console on ls1012a freedom board.
Initially on this board RCW file was flashed using codewarrior tap . After than this board did not come up with u-boot console.
After that I setup yocto on ubuntu (14.04) host system and build binaries using bitbake fsl-image-full command. And flashed PBL file(0x0 offset) and u-boot (0x100000 offset) using codewarrior tap . But result is same. device did not come up with u-boot prompt.
Can anyone help to resolve this issue? Please let me know if I am missing anything.
Regards,
Kishan Patel
If you built RCW and u-Boot with bitbake, make sure you byte-swapped them before programming. Alternatively, use the most recent SDK pre-built u-Boot and RCW. Visit the link below to download SDK pre-built binaries:
https://www.nxp.com/products/developer-resources/run-time-software/linux-sdk/linux-sdk-for-qoriq-processors:SDKLINUX?tab=Design_Tools_Tab
Other recommendations for u-Boot/RCW deployment and board recovery can be found at the links below:
https://freescale.sdlproducts.com/LiveContent/content/en-US/QorIQ_SDK/GUID-B5527E85-8C52-424B-89F2-EADA03020181
https://freescale.sdlproducts.com/LiveContent/content/en-US/QorIQ_SDK/GUID-6E44B664-2DFD-4695-9801-701AD8CB0B9D
Have a great day,
Platon
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------