Rotary dryer

The dryer is made up of a large, rotating cylindrical tube, usually supported by concrete
columns or steel beams. The dryer slopes slightly so that the discharge end is
lower than the material feed end in order to convey the material through the
dryer under gravity. Material to be dried enters the dryer, and as the dryer
rotates, the material is lifted up by a series of internal fins lining the
inner wall of the dryer. When the material gets high enough to roll back off
the fins, it falls back down to the bottom of the dryer, passing through the
hot gas stream as it falls. This gas stream can either be moving toward the
discharge end from the feed end (known as co-current flow), or toward the feed
end from the discharge end (known as counter-current flow). The gas stream can
be made up of a mixture of air and combustion gases from a burner, in which
case the dryer is called a direct heated dryer . Based on the
configuration, rotary dryers can be classified as co-current, counter current,
direct fired and indirect fired. Explanation of each configuration is given
below:

Dingli's Rotary Dryer Unique Features: 1, Adopt our potented design for raiseing board.

2, Adopt  frequency conversion  control for main part.

3, Adopt self-aligning riding wheel device.

4, Temperature monitoring at input and output port.

5, Equipped with emergency exhaust device to prevent explosion

 

来自 “ ITPUB博客 ” ，链接：http://blog.itpub.net/30139123/viewspace-1445122/，如需转载，请注明出处，否则将追究法律责任。

转载于:http://blog.itpub.net/30139123/viewspace-1445122/