lime making lineUsage and Application
Lime can be divided into ordinary lime and active lime according to the nature. The degree of activity is generally less than 200ml, which is mainly used for building and repairing roads. Active lime has a high degree with the value of 300-420ml as well as with advantage of high porosity, high reaction, and low consumption in process, controllable process, widely applied to the steel smelting, calcium carbide, chemical industry, desulfurization and etc.
Working Principle
Qualified limestone stores in silos and be shipped through the pre-heater by the elevator into the silos which is on the top of the pre-heater. The pre-heater on the top of silos is consisted of top and bottom level meter controllers which control the feeding capacity. Then through the feed tube the limestone is distributed to the indoor compartment of the pre-heater.
The limestone in the pre-heater is heated to around 900 ° C by the kiln flue gas of 1150 ° C. At this time, about 30% of the limestone has been decomposition. Then the limestone is put into the rotary kiln by the hydraulic stem. In the rotary kiln the limestone sinters and decomposes into CaO and CO2. Then the decomposed limestone goes into the cooler and is cooled to about 100 ° C by the cold air and then is discharged. The 600 ° C hot air after heat exchange goes into the kiln and combusts with gas. The Exhaust gas blended with the cold wind go to the bag filter through the suction fan and then through the exhaust fan into the chimney.
The limestone out of the cooler enters into the lime storehouse through the vibrating feeder, chain bucket conveyor, bucket elevator and belt conveyor. Whether to carry out screening and other procedures depends on customer requirements.
Features
1. Good quality and high output, suitable for large-scale activity of lime production line and large-scale production.
2. Stable production, all the production with the negative pressure, air flow and higher security.
3. Simple structure, easy control and beneficial operation and maintenance.
4. Fine grade limestone can be calcined, full use of mine resources.
5. Low heat consumption per unit of product, installation in vertical kiln per heated kiln can take advantage of exhaust warm limestone, greatly reducing the fuel consumption.
6. Making full use of industrial waste gas as a fuel for lime burning (such as blast furnace exhaust gas, acetylene tail gas, charcoal blue exhaust, etc)
7. Kiln head adopts the design of vertical cooler integrating kiln head cover. The construction area is small, good sealing, effectively avoiding hot waste gas emissions unsystematically.
8. Environmental protection, the adoption of pulse bag filter dust collecting dust, discharge concentration less than 50mg Nm3/ and below national emission standard (less than 100mg/Nm3)
9. High automation level, the adjustment of production system operation, control and alarm adopts PLC to control in the control center room, reducing artificial and improving efficiency.
Copyright Statement
The ownership of all the information including the photos and product specifications belongs to Great Wall Heavy Industry, If reproduced, please indicate the original source and the statement of the enterprise, any infringement may lead to the civil,administrative or criminal responsibility.
Related Products
http://www.great-wall-mill.com/
http://www.china-stone-crusher.com/
http://www.great-wall-cone-crusher.com/
E-mail:greatwallgroups@163.com
来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/28933759/viewspace-762925/,如需转载,请注明出处,否则将追究法律责任。
转载于:http://blog.itpub.net/28933759/viewspace-762925/