1. In the File menu, click
Set Up Domain > NTP.
2. In the NTP Configuration dialog box, enter the IP address, and optionally the Key ID and Key Value for the NTP server you are adding.
3. To enable NTP for the attached supported storage systems, select Enable NTP.
Note This option does not affect NTP server settings.
4. In Time Sync Interval, specify the time interval that the storage system will use to synchronize with the time server.
The minimum interval is 30 minutes; the maximum is 30 days. Once or twice per day is generally sufficient for most uses
Note If you use CLI to add time intervals that are not in the standard UI list, the new CLI intervals will be visible the next time you use the UI option.
5. Click OK to save any changes and close the dialog box.
2. In the NTP Configuration dialog box, enter the IP address, and optionally the Key ID and Key Value for the NTP server you are adding.
3. To enable NTP for the attached supported storage systems, select Enable NTP.
Note This option does not affect NTP server settings.
4. In Time Sync Interval, specify the time interval that the storage system will use to synchronize with the time server.
The minimum interval is 30 minutes; the maximum is 30 days. Once or twice per day is generally sufficient for most uses
Note If you use CLI to add time intervals that are not in the standard UI list, the new CLI intervals will be visible the next time you use the UI option.
5. Click OK to save any changes and close the dialog box.
来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/228190/viewspace-681429/,如需转载,请注明出处,否则将追究法律责任。
转载于:http://blog.itpub.net/228190/viewspace-681429/