DFL设备对ST300DM1001-1CH166部分扇区无法访问数据的恢复步骤

This is one successful remote data recovery case study for one DFL user in USA.

这是 一个美国 DFL 用户的远程数据恢复 成功案例 。

 

According to the user’s report, the patient drive could be properly detected and was able to enter F3 T> but when he tried to image the hard drive, he could only image 70% around of the drive and the last 30% of data was blocked. If the user tried to scan the bad sectors, full of bad sectors was found.

根据用户的报告， 故障硬盘 可以被正确地检测并能够进入 F3T> ，但当他 尝试 对硬盘进行 镜像 时，他只能 镜像硬盘的 70% ，而最后 30% 的数据 却无法继续镜像 。如果用户试图扫描坏扇区，就会发现满是坏扇区。

 

The very first thing was to backup the rom, translator, primary defect lists and NG-list and next users tried the DFL auto partial sector access solution, but no bad sectors were found and the log windows reported translator restoration success. That is to say, the problem of the last 30% problem was caused by some other issue.

开始操作时的 第一件事是备份 ROM 、 编译 器、主要缺陷表和 NG 表，下 一步 用户尝 试 DFL 部分扇区访问自动解决方案 ，但是没有发现坏扇区，日志窗口报告 显示编译 器恢复成功。也就是说，最后 30% 的问题是由一些其他的问题造成的。

 

Engineer checked the NG list contents and found some entries inside and next, the engineer fixed NG list with DFL Seagate firmware repair tool, clear defect lists, reset smart and then regenerated translator, power off and on, the drive was perfectly fixed and the last 30% of data was accessible too.

工程师检查了 NG 表内容和发现一些 列表 ，接下来，工程师 使用 DFL 希捷固件修复工具 修复 NG 表， 清除 缺陷表，重置 SMART 然后再生 成译码表 ， 重启 电源，硬盘 完美恢复 最后的百分之三十的数据访问

 

This partial sector access problem for ST3000DM001-1CH166 was fixed within two minutes and the user could finally recover 100% of the data with DFL-DDP data recovery program.

ST300DM1001-1CH166 的部分扇区无法镜像的问题在两分钟内完美修复，用户最终可以用 DFL — DDP 数据恢复程序恢复 100% 的数据。

来自 “ ITPUB博客 ” ，链接：http://blog.itpub.net/31452571/viewspace-2212331/，如需转载，请注明出处，否则将追究法律责任。

转载于:http://blog.itpub.net/31452571/viewspace-2212331/