环境为:2台PIX 535做lan failover。E1做failover联接端口。
注意:通过交叉线互联.端口一定要用100full,不能用100auto
[@more@]具体配置如下:
primary
no failover
interface ethernet1 100full
nameif ethernet1 intf5 security10
ip address intf5 192.168.101.1 255.255.255.252 //主备保持一致
failover ip address intf5 192.168.101.2 //主备保持一致
failover lan unit primary
failover lan interface intf5
failover lan key 12345678
failover lan enable
standby
no failover
interface ethernet1 100full
ip address intf5 192.168.101.1 255.255.255.252 //主备保持一致
failover ip address intf5 192.168.101.2 //主备保持一致
failover lan unit secondary
failover lan interface intf5
failover lan key 12345678
failover lan enable
failover
来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/15192459/viewspace-1009216/,如需转载,请注明出处,否则将追究法律责任。
转载于:http://blog.itpub.net/15192459/viewspace-1009216/