For the successful operation of the Oracle 10g database software on Linux-based systems, Oracle recommends the customization of the kernel parameters shown in this Table: Kernel Parameter Recommended Values | ||
Kernel Parameter | Recommended Value | remark |
kernel.sem (semmsl) | 250 | 每个信号对象集的最大信号对象数; |
kernel.sem (semmns) | 32000 | 系统范围内最大信号对象数; |
kernel.sem (semopm) | 100 | 每个信号对象支持的最大操作数; |
kernel.sem (semmni) | 128 | 系统范围内最大信号对象集数 |
kernel.shmall | 2097152 | 可以使用的共享内存的总量 |
kernel.shmmax | Half the size of physical memory | 最大共享内存段大小。取物理内存大小的一半,单位为字节 |
kernel.shmmni | 4096 | 整个系统共享内存段的最大数目 |
fs.file-max | 65536 | 系统中所允许的文件句柄最大数目 |
net.core.rmem_default | 262144 | 套接字接收缓冲区大小的缺省值 |
net.core.rmem_max | 262144 | 套接字接收缓冲区大小的最大值 |
net.core.wmem_default | 262144 | 套接字发送缓冲区大小的缺省值 |
net.core.wmem_max | 262144 | 套接字发送缓冲区大小的最大值 |
net.ipv4.ip_local_port_range | 1024 to 65000 | 应用程序可使用的IPv4端口范围 |
kernel.shmall = 2097152 # 可以使用的共享内存的总量。 | ||
kernel.shmmax = 2147483648 # 最大共享内存段大小。取物理内存大小的一半,单位为字节 | ||
kernel.shmmni = 4096 # 整个系统共享内存段的最大数目。 | ||
kernel.sem = 250 32000 100 128 # 每个信号对象集的最大信号对象数;系统范围内最大信号对象数;每个信号对象支持的最大操作数;系统范围内最大信号对象集数。 | ||
fs.file-max = 65536 # 系统中所允许的文件句柄最大数目。 | ||
net.ipv4.ip_local_port_range = 1024 65000 # 应用程序可使用的IPv4端口范围。 | ||
net.core.rmem_default = 1048576 # 套接字接收缓冲区大小的缺省值 | ||
net.core.rmem_max = 1048576 # 套接字接收缓冲区大小的最大值 | ||
net.core.wmem_default = 262144 # 套接字发送缓冲区大小的缺省值 | ||
net.core.wmem_max = 262144 # 套接字发送缓冲区大小的最大值 |
来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/10640532/viewspace-619501/,如需转载,请注明出处,否则将追究法律责任。
转载于:http://blog.itpub.net/10640532/viewspace-619501/