|
|
|
|
|
|
|
|
|
|
emr_na-c01597456-2 -- HP and Customer Viewable
Favorite document name | |
(maximum 50 characters) |
You have reached the maximum number of saved favorite documents. Please select a favorite to overwrite from the dropdown list. | |
Favorite To Overwrite |
You have already saved this link as 'null'. If you want to rename your favorite you can do so in the textbox below | ||
(maximum 50 characters) | ||
Browser doesn't support iframe.
HP StorageWorks Enterprise Virtual Arrays - Procedure to Extend a Vdisk on HP StorageWorks Command View EVA and then on Microsoft Windows Servers
Information
This document explains the steps involved in extending a Vdisk on Command View EVA, and using DiskPart to extend the LUN on a Microsoft Windows server online.
Details
1. Make sure that a working, tested backup of the data is available before making any changes to the LUN and/or the partition.
The following screenshot shows the Computer Management page with the actual size of the LUN (G: ) that is presented from the EVA.
2. In Command View EVA, on the Vdisk that needs to be extended, type the amount of total space the Vdisk needs to have in the Requested Capacity text box.
3. Click Save Changes , and then OK .
The Allocated Capacity will now show the extended Vdisk size.
4. On the Computer Management page of the server, do a rescan of disks by right-clicking Disk Management .
The extended space will be seen as in the following picture.
5. Open DiskPart on the command line.
6. To extend a partition or volume, first select the volume to give it the focus, and then specify how large it should be extended.
7. Type list volume to display the existing volumes on the computer.
8. Type select volume < volume number> where the volume number is the number of the volume that you want to extend.
9. Use the extend command to incorporate unallocated space into an existing volume while preserving the data.
The following are the requirements for the extend command:
The volume must be formatted with the NTFS file system.
Only the extension of data volumes is supported. System or boot volumes may be blocked from being extended, and you may receive the following error:
Diskpart failed to extend the volume. Please make sure the volume is valid for extending
You cannot extend the partition if the system page file is located on the partition. Move the page file to a partition that you do not wish to extend.
10. Type extend [size=n] [disk=n] [noerr] .
The following describes the parameters:
[ size=n ]
The space, in megabytes (MB), to add to the current partition. If you do not specify a size, the disk is extended to take up all of the next contiguous unallocated space.
[ disk=n ]
The dynamic disk on which to extend the volume. Space equal to size=n is allocated on the disk. If no disk is specified, the volume is extended on the current disk.
[ noerr ]
For scripting only. When an error is thrown, this parameter specifies that DiskPart continue to process commands as if the error did not occur. Without the noerr parameter, an error causes DiskPart to quit with an error code.
When the extend command is complete, you should receive a message that states that DiskPart successfully extended the volume . The new space should be added to the existing drive while maintaining the data on the volume.
11. Type exit to quit DiskPart.
The Computer Management page will now show the extended volume.
Privacy Statement | Terms of Use | SAW Portal Version V5.6 | HP Restricted
Copyright (c) 2012 Hewlett-Packard Development Company, L.P.
| ||
来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/167898/viewspace-1057867/,如需转载,请注明出处,否则将追究法律责任。
转载于:http://blog.itpub.net/167898/viewspace-1057867/