aix etherchannel 切换方法和查看方式

1、查看etherchannel的配置，如下ent3为主，ent1为备
dbrac1:/@root>#lsattr -El ent4 
adapter_names   ent3           EtherChannel Adapters                       True
alt_addr        0x000000000000 Alternate EtherChannel Address              True
auto_recovery   yes            Enable automatic recovery after failover    True
backup_adapter  ent1           Adapter used when whole channel fails       True
hash_mode       default        Determines how outgoing adapter is chosen   True
mode            standard       EtherChannel mode of operation              True
netaddr         0              Address to ping                             True
noloss_failover yes            Enable lossless failover after ping failure True
num_retries     3              Times to retry ping before failing          True
retry_time      1              Wait time (in seconds) between pings        True
use_alt_addr    no             Enable Alternate EtherChannel Address       True
use_jumbo_frame no             Enable Gigabit Ethernet Jumbo Frames        True
2、查看当前active的网卡，active为主，即ent3：
dbrac1:/@root>#entstat -d ent4 |grep -i acti 
Active channel: primary channel  
3、切换方法：
Smitty etherchannel->Force A Failover In An EtherChannel / Link Aggregation
4、切换后，可执行#entstat -d ent4 |grep -i acti再次查看

来自 “ ITPUB博客 ” ，链接：http://blog.itpub.net/29446986/viewspace-1735189/，如需转载，请注明出处，否则将追究法律责任。

转载于:http://blog.itpub.net/29446986/viewspace-1735189/