实验12配置ospf

实验任务一：单区域ospf基本配置

1. 搭建实验环境
   

2. 在路由器上配置ip地址
3. 检查网络连通性和路由器路由表

4. 配置ospf
   [RTA]ospf 1 router-id 1.1.1.1
   [RTA-ospf-1]area 0
   [RTA-ospf-1-area-0.0.0.0]network 20.0.0.0 0.0.0.255
   [RTA-ospf-1-area-0.0.0.0]network 10.0.0.0 0.0.0.255
   [RTB]ospf 1 router-id 2.2.2.2
   [RTB-ospf-1]area 0
   [RTB-ospf-1-area-0.0.0.0]network 20.0.0.0 0.0.0.255
   [RTB-ospf-1-area-0.0.0.0]network 10.1.0.0 0.0.0.255
   5.检查路由器ospf邻居状态及路由表
   [RTA]display ospf peer

    OSPF Process 1 with Router ID 1.1.1.1
          Neighbor Brief Information

Area: 0.0.0.0
Router ID Address Pri Dead-Time State Interface
2.2.2.2 20.0.0.2 1 40 Full/BDR GE0/1
[H3C]display ospf routing

     OSPF Process 1 with Router ID 1.1.1.1
              Routing Table

            Topology base (MTID 0)

Routing for network
Destination Cost Type NextHop AdvRouter Area
20.0.0.0/24 1 Transit 0.0.0.0 1.1.1.1 0.0.0.0
10.0.0.0/24 1 Stub 0.0.0.0 1.1.1.1 0.0.0.0
10.1.0.0/24 2 Stub 20.0.0.2 2.2.2.2 0.0.0.0

Total nets: 3
Intra area: 3 Inter area: 0 ASE: 0 NSSA: 0
实验任务2：单区域ospf增强配置
//接口视图下配置ospf接口开销
Interface0/0
Ospf cost 150
//GE0/0接口下修改接口的优先级为0(0不选举)
Interface0/0
Ospf dr-priority 0
//重启ospf进程
<>reset ospf 1 process
实验任务3：多区域ospf基本配置
//查看ospf邻居
Display ospf peer
//查看ip路由表
Display ip routing-table

转载于:https://www.cnblogs.com/akiz/p/11144530.html