Linux As 4.0 下安装IBM Director Server 5.10指南

今天在公司安装IBM Director Server 5.10后，Director server无法正常工作，仔细检查后原来是iptables在作怪，关掉iptalbes后系统就可正常工作，我把我得安装步骤简略总结如下，另外后边附一篇IBM Director Server安装的官方文档。

(1)    下载IBM Director Server　－ C90SBNA.tar

(2)    解压C90SBNA.tar 。命令为

tar xvf C90SBNA.tar

(3)    解压后 进入到  /解压路径/director/server/linux/i386

(4)    运行./dirinstall。进入到自动安装界面

选择数据库是，选择默认的Apache Derbey

(5)    关闭Linux防火墙，命令为：

iptables –F

(6) 启动IBM Director Server

       ./twgstart

(6)    启动配置界面

./twgcon

 

 

Installing IBM Director Server on Linux for xSeries

This topic describes how to install IBM Director Server on a server running Linux for xSeries.

When you install IBM Director Server, IBM Director Console and IBM Director Agent are installed automatically.

Notes:

1. Before you install IBM Director Server on Red Hat Enterprise Linux AS, version 3.0, for Intel x86, make sure that the following RPM file is installed: compat-libstdc++-7.3-2.96.122.i386.rpm

Complete the following steps to install IBM Director Server on Linux:

1. Insert the IBM Director 5.10 CD into the CD-ROM drive.

2. If the CD does not automount, go to step 3. If the CD automounts, type the following command and press Enter:

umount /mnt/cdrom

3. Type the following command and press Enter:

mount /dev/cdrom /mnt/cdrom

4. Change to the directory where the installation script is located. Type the following command and press Enter:

cd /mnt/cdrom/director/server/linux/i386/

5. If you want to customize the installation, go to step 6. If you want to accept the default settings for the installation, type the following command and press Enter:

./dirinstall Go to step 10.

10. Prepare to configure your database application for use with IBM Director. You have the following options: (default Apache Derby)

11  (Apache Derby only) The ″IBM Director Apache Derby configuration″ window opens. The values cannot be changed. Click Next twice and then click OK. Go to step 12

12. To enable encryption or change security settings, type the following command and press Enter: /opt/IBM/director/bin/cfgsecurity

13. To start IBM Director, type the following command and press Enter: /opt/IBM/director/bin/twgstart

14. unmount the CD-ROM drive

15. Remove the IBM Director 5.10 CD from the CD-ROM drive.

注意：在启动director server 之前应该首先关闭防火墙，关闭命令为：

iptalbes –F