闲来无事,折腾下这个NVR,首先找到TTL口,连上TTL线,打开串口工具,波特率设置为115200。
输出:
U-Boot 2010.06 (Sep 12 2014 - 15:20:31)
Check spi flash controller v350... Found
Spi(cs1) ID: 0xEF 0x40 0x18 0x00 0x00 0x00
spi->chipsize:16778240
start_up_mode is 3bite
Spi(cs1): Block:64KB Chip:16385KB Name:"W25Q128B"
Spi(cs1): 3 addr SPI read:0x5,6B,0xc write:0x5,32,0xc erase:0x0,D8,0xc
num_chip of Spi: 1
In: serial
Out: serial
Err: serial
(Re)start USB search...
USB: scanning bus for devices... 1 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot: 0
saveaddr: 82000000
do_netupdate
Hisilicon ETH net controler
MAC: 00-00-23-34-45-66
UP_PORT : phy status change : LINK=UP : DUPLEX=FULL : SPEED=100M
JVUpd Start
OurPort: 1350
starting...
packet not correct: des: 137, our: 1350
packet not correct: des: 137, our: 1350
packet not correc