DBC文件里有关诊断报文的属性（DCM）

来源于 VECTOR文档-Rules for Legacy Communication Description，有对应的中文说明

3.7 Attributes for Diagnostic(DCM)

The following data base attributes are utilized to configure the DCM and CANTP modules.

Attribute Name	Object Type	Type	Values and Ranges(Bold = default)	Desciption	描述
DiagState	Message	Enum	No=0, Yes=1	Set to yes for: Functional (UDS) request CanTp Normal addressing will be used.	功能请求
DiagRequest	Message	Enum	No=0, Yes=1	Set to yes for: Physical request CanTp Normal addressing will be used.	物理请求
DiagResponse	Message	Enum	No=0, Yes=1	Set to yes for: Physical Response CanTp Normal addressing will be used.	物理响应
DiagConnection	Message	Integer	0…0xFFFF	Groups DiagRequest and DiagResponse to one Connection by a similar value of this attribute. The value shall be derived as follows: <TesterAddress><ServerAddr>	支持多个请求及响应 按此属性的类似值将DiagRequest和DiagResponse分组到一个连接。 该值应推导如下： ＜TesterAddress＞＜ServerAddr＞
DiagFdOnly	Message	Enum	No=0, Yes=1	Specifies,to which kind of diag requests the ECU will respond. No(or not available) ECU will respond to diag requests in both formats CAN2.0 and CAN-FD Yes ECU will respond to diag requests in CAN-FD format only Notes:both messages request and response must be given the same attribute value This attribute has no effect on CAN-2.0 frames.	指定ECU将响应哪种诊断请求。 否（或不可用） ECU将以CAN2.0和CAN-FD两种格式响应诊断请求 对 ECU将仅以CAN-FD格式响应诊断请求 注意：消息请求和响应必须具有相同的属性值 此属性对CAN-2.0帧没有影响。

Table 3-7 List of DCM Data Base Attributes