inand驱动问题的解决+一些小问题的修补

《朱老师物联网大讲堂》学习笔记

学习地址：www.zhulaoshi.org

SD/MMC:  unrecognised EXT_CSD structure version 6
unrecognised EXT_CSD structure version 6
Card init fail!
中的关键字EXT_CSD，
通过搜索来定位错误位置，关键字的选取很重要！
drivers/mmc/Mmc.c
static int mmc_read_ext_csd(struct mmc *host)


然后就是讲解这块的代码，


if (ext_csd_struct > 5) {
printf("unrecognised EXT_CSD structure "
"version %d\n", ext_csd_struct);
err = -1;
goto out;
}
把5改成8，






//mmc = find_mmc_device(0);
mmc = find_mmc_device(1);
if (mmc) {
err = mmc_init(mmc);
if (err)
err = mmc_init(mmc);
if (err) {
printf("Card init fail!\n");
return err;
}
}
printf("%ldMB\n", (mmc->capacity/(1024*1024/mmc->read_bl_len)));
return 0;
}
把0改成1，


后来发现其实5不用改成8，

串口号更改，
#define CONFIG_SERIAL3 1
改为
#define CONFIG_SERIAL1 1


include/s5pc110.h
#if defined(CONFIG_SERIAL1)
#define ELFIN_UART_CONSOLE_BASE (ELFIN_UART_BASE + ELFIN_UART0_OFFSET)
#elif defined(CONFIG_SERIAL2)
#define ELFIN_UART_CONSOLE_BASE (ELFIN_UART_BASE + ELFIN_UART1_OFFSET)
#elif defined(CONFIG_SERIAL3)
#define ELFIN_UART_CONSOLE_BASE (ELFIN_UART_BASE + ELFIN_UART2_OFFSET)
#elif defined(CONFIG_SERIAL4)
#define ELFIN_UART_CONSOLE_BASE (ELFIN_UART_BASE + ELFIN_UART3_OFFSET)
#else
#define ELFIN_UART_CONSOLE_BASE (ELFIN_UART_BASE + ELFIN_UART0_OFFSET)
#endif






修改IP地址等信息，
#define CONFIG_ETHADDR 00:40:5c:26:0a:5b
#define CONFIG_NETMASK          255.255.255.0
#define CONFIG_IPADDR 192.168.0.20
#define CONFIG_SERVERIP 192.168.0.10
#define CONFIG_GATEWAYIP 192.168.0.1






#define CFG_PROMPT              "SMDKV210 # "   /* Monitor Command Prompt    
提示符信息，即#前面的字符串，