高通平台9x07linux系统i2c调试经验

如果还没有加载设备只是单纯看i2c通不通，可以用一下方法：
dts配置只使能i2c-2就可以

i2c_2: i2c@78b6000 { /* BLSP1 QUP4 */
		compatible = "qcom,i2c-msm-v2";
		#address-cells = <1>;
		#size-cells = <0>;
		reg-names = "qup_phys_addr";
		reg = <0x78b6000 0x600>;
		interrupt-names = "qup_irq";
		interrupts = <0 96 0>;
		qcom,clk-freq-out = <400000>;
		qcom,clk-freq-in  = <19200000>;
		clock-names = "iface_clk", "core_clk";
		clocks = <&clock_gcc clk_gcc_blsp1_ahb_clk>,
			<&clock_gcc clk_gcc_blsp1_qup2_i2c_apps_clk>;

		pinctrl-names = "i2c_active", "i2c_sleep";
		pinctrl-0 = <&i2c_2_active>;
		pinctrl-1 = <&i2c_2_sleep>;
		qcom,noise-rjct-scl = <0>;
		qcom,noise-rjct-sda = <0>;
		qcom,master-id = <86>;
		dmas = <&dma_blsp1 14 64 0x20000020 0x20>,
			<&dma_blsp1 15 32 0x20000020 0x20>;
		dma-names = "tx", "rx";
		status = "okay";
        
		/*SMI230_ACC@18{
			compatible = "SMI230ACC";
			gpio_irq = <34>;
            interrupt-parent = <&tlmm_pinmux>;
            gpio_irq = <&tlmm_pinmux 34 0x2002>;
			reg = <0x18>;
		};
        
		SMI230_GYRO@68{
			compatible = "SMI230GYRO";
			gpio_irq = <74>;
			reg = <0x68>;
		};*/

系统启动后会在/dev中有i2c-2设备

/dev # ls i2c*
ls i2c*
i2c-2  i2c-4

示波器接上i2c-2时钟引脚，同时在命令行发数据

/dev # echo 0 >i2c-2
echo 0 >i2c-2

如果有波形，就说明i2c-2是通的