linux无法运行yum命令

确实碰到了和版主一样的问题，copy以记
https://www.cnblogs.com/crowsong/p/9371216.html
刚安装的centos7.4，结果运行yum装docker时报错了，报错内容都一模一样，直接copy过来

One of the configured repositories failed (Unknown),
 and yum doesn't have enough cached data to continue. At this point the only
 safe thing yum can do is fail. There are a few ways to work "fix" this:

     1. Contact the upstream for the repository and get them to fix the problem.

     2. Reconfigure the baseurl/etc. for the repository, to point to a working
        upstream. This is most often useful if you are using a newer
        distribution release than is supported by the repository (and the
        packages for the previous distribution release still work).

     3. Disable the repository, so yum won't use it by default. Yum will then
        just ignore the repository until you permanently enable it again or use
        --enablerepo for temporary usage:

            yum-config-manager --disable <repoid>

     4. Configure the failing repository to be skipped, if it is unavailable.
        Note that yum will try to contact the repo. when it runs most commands,
        so will have to try and fail each time (and thus. yum will be be much
        slower). If it is a very temporary problem though, this is often a nice
        compromise:

            yum-config-manager --save --setopt=<repoid>.skip_if_unavailable=true

去看了网卡，各设置项也都正常，网卡也是启动的，ping百度也是通的，最后直接采用了修改文件的方法（以下为copy内容，真的太懒了~~~）
修改CentOS-Base.repo中的地址
若上述方法还是无效可以尝试修改CentOS-Base.repo中的地址
1、进入 “/etc/yum.repos.d” 。
2、编辑 “vi CentOS-Base.repo” 。
3、将所有的 “mirrorlist” 注释掉，将所有的 “baseurl” 取消注释。
搞完后发现reboot命令也不起作用，幸好是虚拟机，直接手动重启。。。。
搞定了，就它的问题