本文详细介绍了如何在Linux系统下利用fdisk命令行工具创建超过5个分区，包括主分区和扩展分区的设定，以及逻辑分区的划分。通过示例展示创建96GB大小分区的过程，最后通过partprobe和partx命令更新分区表。
注：
1、先要有三个主分区，然后是扩展分区(逻辑存在，实际不存在)
2、直接接着分区则为逻辑分区，实际为分割扩展分区
Command (m for help): p
Disk /dev/sda: 750.2 GB, 750156374016 bytes, 1465149168 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk label type: dos
Disk identifier: 0x000d36b1
Device Boot Start End Blocks Id System
/dev/sda1 * 2048 409602047 204800000 83 Linux
/dev/sda2 409602048 442361855 16379904 82 Linux swap / Solaris
Command (m for help): n
Partition type:
Disk /dev/sda: 750.2 GB, 750156374016 bytes, 1465149168 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk label type: dos
Disk identifier: 0x000d36b1
Device Boot Start End Blocks Id System
/dev/sda1 * 2048 409602047 204800000 83 Linux
/dev/sda2 409602048 442361855 16379904 82 Linux swap / Solaris
Command (m for help): n
Partition type:
最低0.47元/天 解锁文章
3661
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
