pi-hole安装到docker并运行

1. Copy docker-compose.yml.example to docker-compose.yml and update as needed. See example below: Docker-compose example:

version: "3"

# More info at https://github.com/pi-hole/docker-pi-hole/ and https://docs.pi-hole.net/
services:
  pihole:
    container_name: pihole
    image: pihole/pihole:latest
    # For DHCP it is recommended to remove these ports and instead add: network_mode: "host"
    ports:
      - "53:53/tcp"
      - "53:53/udp"
      - "67:67/udp" # Only required if you are using Pi-hole as your DHCP server
      - "80:80/tcp"
    environment:
      TZ: 'America/Chicago'
      # WEBPASSWORD: 'set a secure password here or it will be random'
    # Volumes store your data between container upgrades
    volumes:
      - './etc-pihole:/etc/pihole'
      - './etc-dnsmasq.d:/etc/dnsmasq.d'
    #   https://github.com/pi-hole/docker-pi-hole#note-on-capabilities
    cap_add:
      - NET_ADMIN # Required if you are using Pi-hole as your DHCP server, else not needed
    restart: unless-stopped

2. Run docker compose up -d to build and start pi-hole (Syntax may be docker-compose on older systems)

3. Use the Pi-hole web UI to change the DNS settings Interface listening behavior to "Listen on all interfaces, permit all origins", if using Docker's default bridge network setting. (This can also be achieved by setting the environment variable DNSMASQ_LISTENING to all)

备注：

如果遇到启动时说端口已被占用，改为：

ports:

- "8053:53/tcp"

- "8053:53/udp"

- "8067:67/udp" # Only required if you are using Pi-hole as your DHCP server

- "8080:80/tcp"