linux 不能自动mount,nfs系统不能自动挂载

ting Linux ...

NAND read: device 0 offset 0x60000, size 0x200000

Reading data from 0x25f800 -- 100% complete.

2097152 bytes read: OK

## Booting image at 30007fc0 ...

Image Name:   Linux-2.6.22.6

Created:      2013-08-23   7:33:38 UTC

Image Type:   ARM Linux Kernel Image (uncompressed)

Data Size:    1848668 Bytes =  1.8 MB

Load Address: 30008000

Entry Point:  30008000

VerIFying Checksum ... OK

XIP Kernel Image ... OK

Starting kernel ...

Uncompressing Linux...................................................................................................................... done, booting the kernel.

Linux version 2.6.22.6 (book@book-desktop) (gcc version 3.4.5) #1 Fri Aug 23 15:33:35 CST 2013

CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177

Machine: SMDK2440

Memory policy: ECC disabLED, Data cache writeback

CPU S3C2440A (id 0x32440001)

S3C244X: core 400.000 MHz, memory 100.000 MHz, peripheral 50.000 MHz

S3C24XX clocks, (c) 2004 Simtec Electronics

CLOCK: Slow mode (1.500 MHz), fast, MPLL on, UPLL on

CPU0: D VIVT write-back cache

CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets

CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets

Built 1 zonelists.  Total pages: 16256

Kernel command line: noinitrd root=/dev/nfs nfsroot=172.18.197.120:/home/book/project/first_fs ip=172.18.197.121:172.18.197.120:172.18.197.188:255.255.255.0::eth0:off init=/linuxrc console=ttySAC0

irq: clearing pending ext status 00000300

irq: clearing subpending status 00000002

PID hash table entries: 256 (order: 8, 1024 bytes)

timer tcon=00500000, tcnt a2c1, tcfg 00000200,00000000, usec 00001eb8

Console: colour dummy device 80x30

Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)

Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)

Memory: 64MB = 64MB total

Memory: 60976KB available (3264K code, 458K data, 140K init)

Mount-cache hash table entries: 512

CPU: Testing write buffer coherency: ok

NET: Registered protocol family 16

S3C2410 Power Management, (c) 2004 Simtec Electronics

S3C2440: Initialising architecture

S3C2440: IRQ Support

S3C2440: Clock Support, DVS off

S3C24XX DMA Driver, (c) 2003-2004,2006 Simtec Electronics

DMA channel 0 at c4800000, irq 33

DMA channel 1 at c4800040, irq 34

DMA channel 2 at c4800080, irq 35

DMA channel 3 at c48000c0, irq 36

SCSI subsystem initialized

usbcore: registered new inteRFace driver usbfs

usbcore: registered new interface driver hub

usbcore: registered new device driver usb

NET: Registered protocol family 2

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 2048 (order: 2, 16384 bytes)

TCP bind hash table entries: 2048 (order: 1, 8192 bytes)

TCP: Hash tables configured (established 2048 bind 2048)

TCP reno registered

NetWinder Floating Point Emulator V0.97 (double precision)

Registering GDB sysrq handler

JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.

yaffs Aug 23 2013 15:33:07 Installing.

io scheduler noop registered

io scheduler anticipatory registered (default)

io scheduler deadline registered

io scheduler cfq registered

Console: switching to colour frame buffer device 60x34

fb0: s3c2410fb frame buffer device

lp: driver loaded but no devices found

ppdev: user-space parallel port driver

S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics

Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled

s3c2440-uart.0: s3c2410_serial0 at MMIO map 0x50000000 mem 0xf0400000 (irq = 70) is a S3C2440

s3c2440-uart.1: s3c2410_serial1 at MMIO map 0x50004000 mem 0xf0404000 (irq = 73) is a S3C2440

s3c2440-uart.2: s3c2410_serial2 at MMIO map 0x50008000 mem 0xf0408000 (irq = 76) is a S3C2440

RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize

loop: module loaded

line 400 I/O: c486a000, VID: 90000a46

line 408 I/O: c486a000, VID: 90000a46

error version, chip_revision = 0x1a, chip_info = 0x3

id_val=0

S3C24XX NAND Driver, (c) 2004 Simtec Electronics

s3c2440-nand s3c2440-nand: Tacls=3, 30ns Twrph0=7 70ns, Twrph1=3 30ns

NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB 3,3V 8-bit)

Scanning device for bad blocks

Bad eraseblock 831 at 0x067e0000

Bad eraseblock 1024 at 0x08000000

Bad eraseblock 1253 at 0x09ca0000

Creating 4 MTD partitions on "NAND 256MiB 3,3V 8-bit":

0x00000000-0x00040000 : "bootloader"

0x00040000-0x00060000 : "params"

0x00060000-0x00260000 : "kernel"

0x00260000-0x10000000 : "root"

s3c2410-ohci s3c2410-ohci: S3C24XX OHCI

s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1

s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000

usb usb1: configuration #1 chosen from 1 choice

hub 1-0:1.0: USB hub found

hub 1-0:1.0: 2 ports detected

Initializing USB Mass Storage driver...

usbcore: registered new interface driver usb-storage

USB Mass Storage support registered.

mice: PS/2 mouse device common for all mice

s3c2410 TouchScreen successfully loaded

input: s3c2410 TouchScreen as /class/input/input0

S3C24XX RTC, (c) 2004,2006 Simtec Electronics

s3c2440-i2c s3c2440-i2c: slave address 0x10

s3c2440-i2c s3c2440-i2c: bus frequency set to 390 KHz

s3c2440-i2c s3c2440-i2c: i2c-0: S3C I2C adapter

mapped channel 0 to 0

s3c2440-sdi s3c2440-sdi: powered down.

s3c2440-sdi s3c2440-sdi: initialisation done.

s3c2440-sdi s3c2440-sdi: running at 0kHz (requested: 0kHz).

s3c2440-sdi s3c2440-sdi: running at 196kHz (requested: 195kHz).

s3c2440-sdi s3c2440-sdi: running at 196kHz (requested: 195kHz).

s3c2440-sdi s3c2440-sdi: running at 196kHz (requested: 195kHz).

usbcore: registered new interface driver hiddev

s3c2440-sdi s3c2440-sdi: CMD[TIMEOUT] #2 op:UNKNOWN(8) arg:0x000001aa flags:0x0875 retries:0 Status:nothing to complete

s3c2440-sdi s3c2440-sdi: CMD[TIMEOUT] #3 op:APP_CMD(55) arg:0x00000000 flags:0x0875 retries:0 Status:nothing to complete

usbcore: registered new interface driver usbhid

drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver

Advanced Linux Sound Architecture Driver Version 1.0.14 (Thu May 31 09:03:25 2007 UTC).

s3c2440-sdi s3c2440-sdi: CMD[TIMEOUT] #4 op:APP_CMD(55) arg:0x00000000 flags:0x0875 retries:0 Status:nothing to complete

ASoC version 0.13.1

s3c2440-sdi s3c2440-sdi: CMD[TIMEOUT] #5 op:APP_CMD(55) arg:0x00000000 flags:0x0875 retries:0 Status:nothing to complete

s3c2410iis_probe...

s3c2440-sdi s3c2440-sdi: CMD[TIMEOUT] #6 op:APP_CMD(55) arg:0x00000000 flags:0x0875 retries:0 Status:nothing to complete

s3c2440-sdi s3c2440-sdi: CMD[TIMEOUT] #7 op:ALL_SEND_OCR(1) arg:0x00000000 flags:0x0861 retries:0 Status:nothing to complete

s3c2440-sdi s3c2440-sdi: powered down.

UDA1341 audio driver initialized

ALSA device list:

No soundcards found.

TCP cubic registered

NET: Registered protocol family 1

drivers/rtc/hctosys.c: unable to open rtc device (rtc0)

IP-Config: Complete:

device=eth0, addr=172.18.197.121, mask=255.255.255.0, gw=172.18.197.188,

host=172.18.197.121, domain=, nis-domain=(none),

bootserver=172.18.197.120, rootserver=172.18.197.120, rootpath=

Looking up port of RPC 100003/2 on 172.18.197.120

Looking up port of RPC 100005/1 on 172.18.197.120

VFS: Mounted root (nfs filesystem).

Freeing init memory: 140K

Warning: unable to open an initial console.

0