android mtk平台的fm停止搜索,MTK6735 一直在启动kernel时重启？

最近调试新的模块，MTK6735 主控，开机到第一屏然后卡住，过一会重启，

重启前，最后的串口日志信息如下：

[   18.226437].(3)[233:wmt_loader][FM_NTC | MAIN]fm_env_setup

[   18.226442].(3)[233:wmt_loader][FM_NTC | MAIN]1. fm callback registered

[   18.226473].(3)[233:wmt_loader][FM_NTC | MAIN]2. fm low ops registered

[   18.226478].(3)[233:wmt_loader][FM_NTC | MAIN]3. fm rds ops registered

[   18.226537].(3)[233:wmt_loader][FM_NTC | MAIN]4. fm locks created

[   18.226552].(3)[233:wmt_loader][FM_NTC | MAIN]5. fm timer created

[   18.226573].(3)[233:wmt_loader][FM_NTC | LINK]fm link setup

[   18.226597].(3)[233:wmt_loader][FM_NTC | LINK]cmd_fifo created

[   18.226616].(3)[233:wmt_loader][FM_NTC | LINK]evt_fifo created

[   18.227145].(3)[233:wmt_loader][pdev] fm

[   18.227152].(3)[233:wmt_loader]  s:18226619692 e:18227139615 d:519923

[   18.227654].(3)[233:wmt_loader][FM_NTC | MAIN]mt_fm_probe

[   18.227665].(3)[233:wmt_loader][FM_NTC | MAIN]pwr state set to 0

[   18.248042]<2>.(2)[258:mtk_wmtd][WMT-PLAT][I]wmt_plat_dump_pin_conf:[WMT-PLAT]=>dump wmt pin configuration start<=

[   18.249368].(2)[258:mtk_wmtd][WMT-PLAT][I]wmt_plat_dump_pin_conf:BGF_EINT(not defined)

[   18.249375].(2)[258:mtk_wmtd][WMT-PLAT][I]wmt_plat_dump_pin_conf:BGF_EINT_NUM(not defined)

[   18.249380].(2)[258:mtk_wmtd][WMT-PLAT][I]wmt_plat_dump_pin_conf:UART_RX(not defined)

[   18.249385].(2)[258:mtk_wmtd][WMT-PLAT][I]wmt_plat_dump_pin_conf:FM digital mode is not set, no need for I2S GPIOs

[   18.249390].(2)[258:mtk_wmtd][WMT-PLAT][I]wmt_plat_dump_pin_conf:GPS_SYNC(not defined)

[   18.249396].(2)[258:mtk_wmtd][WMT-PLAT][I]wmt_plat_dump_pin_conf:GPS_LNA(GPIO-2147483562)

[   18.249401].(2)[258:mtk_wmtd][WMT-PLAT][I]wmt_plat_dump_pin_conf:[WMT-PLAT]=>dump wmt pin configuration emds<=

[   18.249406].(2)[258:mtk_wmtd][WMT-CONSYS-HW][I]mtk_wcn_consys_hw_pwr_on:CONSYS-HW-PWR-ON, start

[   18.249412].(2)[258:mtk_wmtd][WMT-CONSYS-HW][I]mtk_wcn_consys_hw_reg_ctrl:CONSYS-HW-REG-CTRL(0x00000001),start

[   18.249444].(2)[258:mtk_wmtd]VCN18: operation not allowed

[   18.249507].(2)[258:mtk_wmtd][PMIC] hwPowerOn:VCN18 set voltage 1800000 fail[PMIC] regulator_is_enabled(name=VCN18 id=0 en_reg=5ea vol_reg=0 en=0)

[   18.249584].(2)[258:mtk_wmtd][PMIC] regulator_enable(name=VCN18 id=0 en_reg=5ea vol_reg=0) [a3a]=0x8102

[   18.249709].(0)[233:wmt_loader][FM_NTC | MAIN]MT6627 FM default config

[   18.249715].(0)[233:wmt_loader][FM_NTC | MAIN]MT6627 rssi_l:        -296

[   18.249720].(0)[233:wmt_loader][FM_NTC | MAIN]MT6627 rssi_s:        -296

[   18.249727].(0)[233:wmt_loader][FM_NTC | MAIN]MT6627 pamd_th:        -12

[   18.249732].(0)[233:wmt_loader][FM_NTC | MAIN]MT6627 mr_th:        -67

[   18.249737].(0)[233:wmt_loader][FM_NTC | MAIN]MT6627 atdc_th:        3496

[   18.249742].(0)[233:wmt_loader][FM_NTC | MAIN]MT6627 prx_th:        64

[   18.249746].(0)[233:wmt_loader]

[   18.249750].(2)[258:mtk_wmtd][PMIC] hwPowerOn:24:VCN18 volt:1800000 name:wcn_drv cnt:1

[   18.249753].(2)[258:mtk_wmtd]

[   18.249756].(0)[233:wmt_loader][FM_NTC | MAIN]MT6627 smg_th:        16421

[   18.249761].(0)[233:wmt_loader][FM_NTC | MAIN]de_emphasis:        0

[   18.249766].(0)[233:wmt_loader][FM_NTC | MAIN]osc_freq:        0

[   18.249772].(0)[233:wmt_loader][FM_NTC | MAIN]aud path[1]I2S state[1]mode[0]rate[0]

[   18.250059].(2)[258:mtk_wmtd][WMT-CONSYS-HW][I]mtk_wcn_consys_hw_reg_ctrl:reg dump:CONSYS_CPU_SW_RST_REG(0x9000)

[   18.250086].(2)[258:mtk_wmtd][WMT-CONSYS-HW][I]mtk_wcn_consys_hw_reg_ctrl:conn_power_on ok

[   18.250093].(2)[258:mtk_wmtd][WMT-CONSYS-HW][I]mtk_wcn_consys_hw_reg_ctrl:reg dump:CONSYS_PWR_CONN_ACK_REG(0x80be4e)

[   18.250099].(2)[258:mtk_wmtd][WMT-CONSYS-HW][I]mtk_wcn_consys_hw_reg_ctrl:reg dump:CONSYS_PWR_CONN_ACK_S_REG(0x80be4e)

[   18.250105].(2)[258:mtk_wmtd][WMT-CONSYS-HW][I]mtk_wcn_consys_hw_reg_ctrl:reg dump:CONSYS_TOP1_PWR_CTRL_REG(0xd)

[   18.250132].(2)[258:mtk_wmtd][WMT-CONSYS-HW][I]mtk_wcn_consys_hw_reg_ctrl:enable MT_CG_INFRA_CONNMCU_BUS CLK

[   18.250427].(2)[1:init]init: process 'stop_modem', pid 263 exited

[   18.272713].(1)[1:init]SELinux: Loaded file_contexts from /file_contexts