Linux怎么确定信号来源,linux – 如何找出POSIX信号的来源

sigaction(2)的手册页建议信号发送器的PID在传递给信号处理程序的siginfo_t结构中可用.这显然要求您使用sigaction().

从手册页：

sigaction结构定义为：

struct sigaction {

void (*sa_handler)(int);

void (*sa_sigaction)(int,siginfo_t *,void *);

sigset_t sa_mask;

int sa_flags;

void (*sa_restorer)(void);

};

siginfo_t结构如下所示：

siginfo_t {

int si_signo; /* Signal number */

int si_errno; /* An errno value */

int si_code; /* Signal code */

int si_trapno; /* Trap number that caused

hardware-generated signal

(unused on most architectures) */

pid_t si_pid; /* Sending process ID */

uid_t si_uid; /* Real user ID of sending process */

int si_status; /* Exit value or signal */

clock_t si_utime; /* User time consumed */

clock_t si_stime; /* System time consumed */

sigval_t si_value; /* Signal value */

int si_int; /* POSIX.1b signal */

void *si_ptr; /* POSIX.1b signal */

int si_overrun; /* Timer overrun count; POSIX.1b timers */

int si_timerid; /* Timer ID; POSIX.1b timers */

void *si_addr; /* Memory location which caused fault */

int si_band; /* Band event */

int si_fd; /* File descriptor */

}