sew 31系列服务器报警12,SEW变频器MOVITRAC-31C系列故障代码表

错误代码

型号

品牌

错误类型

错误原因

解决办法

1

MOVITRAC-31C

SEW

Overcurrent

Short circuit/earth fault at the output.Motor too large.Faulty

output stage.

Remove short-circuit.Connect smaller motor.If fault can still

not be reset,contact SEW service.

2

MOVITRAC-31C

SEW

DC link voltage

DC link voltage too high.

Increase deceleration ramps.

3

MOVITRAC-31C

SEW

Brake chopper

Regenerative power too highBraking resistor circuit

interruptedShort-circuit in the brakingresistor circuitBraking

resistance value too highFaulty brake chopper

Increase deceleration ramps.Check connecting leads of

thebraking resistor.Check technical data of thebraking

resistor.Exchange MOVITRAC® 31C

5

MOVITRAC-31C

SEW

Regenerativeoverload

With active regen. n monit. (P520/P522)and speed control

(P770):faulty encoder signalswrong number of pole pairs

(P324/P344)value of increments (P773) not correct

Check encoder.Check encoder connection.Set number of pole pairs

correctly.Set value of increments correctly.

4

MOVITRAC-31C

SEW

Cont. overload

´t utilization too high (> 125(%)).

Reduce load.

6

MOVITRAC-31C

SEW

Overtemperature

Thermal overload of the inverter.

Reduce load and / or ensure adequatecooling.

7

MOVITRAC-31C

SEW

Phase failure

With active mains volt. monitor.(P530)Phase missing at TL.

X1:1/2/3.

Check mains supply.

10

MOVITRAC-31C

SEW

Direction ofrotation

Only with active speed control (P770):Encoder tracks A/A and

B/B areswapped in pairs.Motor rotates in opposite direction.Regen.

overload (i.e. with sagging hoist)because of excessive load or

BOOSTsetting too low (P321/P341).

Check encoder connection.Exchanging two motor phases.Reduce

load or i