ap drawing 课件_ILITEK TP AP introduction.ppt

ILITEK TP AP introduction

Drawing Direction – module test Button L/R Sensor test AP Condition Condition 选择 interface I2C USB I2C选项 I2C default addr : 0x82 I2C default length : 9 测试时间限制 F/W Programming F/W Programming 2102/2103 TP Module Programming Set up I2C I/F USB I/F 奕力tool I2C Master 奕力tool Writer TS测点 2102/03 F/W Programming 按writer button 连线 F/W Programming 连线成功 F/W Programming Load HEX file F/W Programming F/W Programming Thank You Very Much Sensor test AP ProFile Create ProFile Create (进阶版) 选择一块 Sensor标准品当基准 勾选 Load BenchMark 勾选 trace loading 勾选 All Node 给定window 值 X/Y Max/Min会自动计算 ProFile Create (进阶版) 按 Connection 取消勾选 load benchmark 选择 Sensor Test item 选择 Module Test item 其它设定 information Save ProFile Sensor test AP (进阶版) Sensor Test Sensor test – start to test (进阶版) 按 connection button I2C or USB连线 比对 F/W version Profile MCU F/W version Sensor test – Trace loading (进阶版) FPC 走线的Sensor平整度数据 X channel Y channel Sensor test – Pass condition (进阶版) 如果pass, sensor 对应图没有变化，代表pass 32(X) : 17(Y) Sensor Sensor test–trace loading - window(进阶版) Window 值为测试容许误差 Window建议值 10 ex : X1 : 179 179+10 < 容許範圍 < 179-10 Sensor test – Trace Loading (进阶版) Trace loading fail Sensor test – X Trace Fail (进阶版) X trace loading benchmark X trace read trace loading Sensor test – Y Trace Fail (进阶版) Y trace loading benchmark Y trace read trace loading Sensor test – All Node (进阶版) Y Driven (Benchmark) Sensor Matrix 平整度 Sensor test – All Node (进阶版) X Driven(Benchmark) Sensor Matrix平整度 Sensor test – All Node - window (进阶版) Window值为测试容许误差 Window建议值 25 Y driven范围 : Ex : 183为 benchmark最大值 + window值 92为 benchmark最小值 - window值 X driven范围 : Sensor test – All Node (进阶版) Test fail Sensor test – All Node (进阶版) Open/Short Test Fail ? 整條都255 or 0 Sensor test – All Node (进阶版) 針對該處OM 觀察 All nodes: Y driven Bridge 破掉情況 Sensor test AP Module Test Module test – single point Module test – single point T