Heavy rotor impact crusher can make full use of the impact force of the rotor, which is usually used for coarse crushing, breaking or crushing of limestone, coal, calcium carbide, quartz, dolomite, iron pyrites, gypsum and chemical raw materials, following hard brittle materials.The crusher is a use of impact energy to break the materials broken machinery. The work of the machine, driven by the motor, the rotor high-speed rotation, the material into the active region of the plate hammer, impact crusher board hammer on the rotor, and then was thrown to the counter-attack on the device again broken, and then from the counter Liner bounced back into the active region of the plate hammer to re-broken, this process is repeated, material descending into a fight back cavity of the second and third repeated broken until the material is broken to the desired particle size, from the discharge port. The heavy-duty rotor crusher has a simple structure, large crushing ratio, low power consumption, high output, light weight, cubic shape and the advantages of the end product was broken. Compared with hammer crusher, impact crusher broken, and can make better use of high-speed impact energy of the entire rotor.Crusher broken material particle size is quite good. Of the finished tablets good comprehensive performance by the favor of the sand and gravel plant, sand and gravel production in the high-speed railway, highway, and construction industries, the crusher for the necessary equipment; coupled with the crusher discharge grain shape into a polyhedron, linked closely together, and concrete national highway to the specified device.In the crusher, the speed is an important factor to affect the counterattack crusher broken quality, efficiency and life, but the crushing effect does not always increase as the speed increases, high speed can also exacerbate the wear of the main butt head , seriously affecting the crusher life. In addition, in order to fully take into account the quality, efficiency and service life of crusher broken, reducing the value and frequency of the maximum impact is crucial, and therefore only need to consider the optimization of the rotor structure and related parameters, and also to analyze the impact of feed particle size uniformity. Stones and the butt ends of the main collision region is also very important.
转载于:https://www.cnblogs.com/a122571245/archive/2012/04/26/2471505.html