几种压缩方式：zlib

zlib：zlib.h http://www.zlib.net/manual.html

编译时加 -lz

ZEXTERN int ZEXPORT compress OF((Bytef *dest, uLongf *destLen,
                                 const Bytef *source, uLong sourceLen));

Compresses the source buffer into the destination buffer. sourceLen is the byte length of the source buffer. Upon entry, destLen is the total size of the destination buffer, which must be at least the value returned by compressBound(sourceLen). Upon exit, destLen is the actual size of the compressed buffer.

compress returns Z_OK if success, Z_MEM_ERROR if there was not enough memory, Z_BUF_ERROR if there was not enough room in the output buffer.

ZEXTERN int ZEXPORT compress2 OF((Bytef *dest, uLongf *destLen,
                                  const Bytef *source, uLong sourceLen,
                                  int level));

Compresses the source buffer into the destination buffer. The level parameter has the same meaning as in deflateInit. sourceLen is the byte length of the source buffer. Upon entry, destLen is the total size of the destination buffer, which must be at least the value returned by compressBound(sourceLen). Upon exit, destLen is the actual size of the compressed buffer.

compress2 returns Z_OK if success, Z_MEM_ERROR if there was not enough memory, Z_BUF_ERROR if there was not enough room in the output buffer, Z_STREAM_ERROR if the levelparameter is invalid.

ZEXTERN uLong ZEXPORT compressBound OF((uLong sourceLen));

compressBound() returns an upper bound on the compressed size after compress() or compress2() on sourceLen bytes. It would be used before a compress() or compress2() call to allocate the destination buffer.

ZEXTERN int ZEXPORT uncompress OF((Bytef *dest, uLongf *destLen,
                                   const Bytef *source, uLong sourceLen));

Decompresses the source buffer into the destination buffer. sourceLen is the byte length of the source buffer. Upon entry, destLen is the total size of the destination buffer, which must be large enough to hold the entire uncompressed data. (The size of the uncompressed data must have been saved previously by the compressor and transmitted to the decompressor by some mechanism outside the scope of this compression library.) Upon exit, destLen is the actual size of the compressed buffer.

uncompress returns Z_OK if success, Z_MEM_ERROR if there was not enough memory, Z_BUF_ERROR if there was not enough room in the output buffer, or Z_DATA_ERROR if the input data was corrupted or incomplete. In the case where there is not enough room, uncompress() will fill the output buffer with the uncompressed data up to that point.

 

转载于:https://www.cnblogs.com/yejinru/p/4165709.html