在oracle10g下启动服务报 Permission denied错误解决方法

安装的系统为redhat5.1 + oracle10g  启动数据库的一个服务时一直报 Permission denied 错误

检查可能是统安全屏蔽了oracle执行某些执行动作。于是检查系统防火墙iptables，已经关闭，于是想到了Selinux

 

检查配置文件：

 

[root@localhost ~]# more /etc/sysconfig/selinux

# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - SELinux is fully disabled.
SELINUX=enforcing
# SELINUXTYPE= type of policy in use. Possible values are:
# targeted - Only targeted network daemons are protected.
# strict - Full SELinux protection.
SELINUXTYPE=targeted
[root@localhost ~]# vi /etc/sysconfig/selinux

 

果然selinux是开启的  关闭selinux

[root@localhost ~]# vi /etc/sysconfig/selinux

# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - SELinux is fully disabled.
SELINUX=disabled
# SELINUXTYPE= type of policy in use. Possible values are:
# targeted - Only targeted network daemons are protected.
# strict - Full SELinux protection.
SELINUXTYPE=targeted
修改SELINUX=disabled，然后重启系统才能生效，或者执行：setenforce 0，立即生效。

关闭selinux后，sqlplus可以正常登陆了。 服务也能正常启动了。

 

转载于:https://www.cnblogs.com/yamin-wanghc/p/5967528.html