linux 添加 声卡驱动,请问在linux下如何安装声卡驱动程序

第一次装linux,成功了,界面好棒,可是一进去就提示声卡驱动有问题,找来主板的driver,可是看不懂哈,那位高手帮忙翻一下,谢谢

STEPS TO BUILD DRIVER

====================================================

1. Backup the Config.in and Makefile in the sound driver directory

(/usr/src/linux/driver/sound).

The Configure.help provide help when you config driver in step

4, please backup the original one (/usr/src/linux/Document) and

copy this file.

The cmpci is document for the driver in detail, please copy it

to /usr/src/linux/Document/sound so you can refer it. Backup if

there is already one.

2. Extract the tar file by 'tar xvzf cmpci-xx.tar.gz' in the above

directory.

3. Change directory to /usr/src/linux

4. Config cm8338 driver by 'make menuconfig', 'make config' or

'make xconfig' command.

5. Please select Sound Card (CONFIG_SOUND=m) support and CMPCI

driver (CONFIG_SOUND_CMPCI=m) as modules. Resident mode not tested.

For driver option, please refer 'DRIVER PARAMETER'

6. Compile the kernel if necessary.

7. Compile the modules by 'make modules'.

8. Install the modules by 'make modules_install'

INSTALL DRIVER

====================================================

1. Before first time to run the driver, create module dependency by

'depmod -a'

2. To install the driver manually, enter 'modprobe cmpci'.

3. Driver installation for various distributions:

a. Slackware 4.0

Add the 'modprobe cmpci' command in your /etc/rc.d/rc.modules

file.so you can start the driver automatically each time booting.

b. Caldera OpenLinux 2.2

Use LISA to load the cmpci module.

c. RedHat 6.0 and S.u.S.E. 6.1

Add following command in /etc/conf.modules:

alias sound cmpci

also visit http://www.cmedia.com.tw for installation instruction.

DRIVER PARAMETER

====================================================

Some functions for the cm8738 can be configured in Kernel Configuration

or modules parameters. Set these parameters to 1 to enable.

spdif_loop:   Enable S/PDIF loop, this route S/PDIF-in to S/PDIF-out

directly.

four_ch:      Enable 4 channels mode, rear-out or line-in will output

the same as line-out.

rear_out:     Enable this if you have independent rear-out jacket on

your sound card, otherwise line-in will be used as

rear-out.

modem:        You will need to set this parameter if you want to use

the HSP modem. You need install the pctel.o, the modem

driver itself.

joystich:        Enable joystick. You will need to install Linux joystick

driver.

原来的"====" 分割线把帖子撑破了，修改了一下。

---啸 留字