cisco串口

Below is a sample configuration for the WIC-1T interface card.

Note: There are no framing, clocking, or linecode parameters or commands being used here. The WIC-1T interface card does not have an integrated CSU/DSU. You need to use an external CSU/DSU.

Configure the serial interface just as you would any other serial interface. For example,

maui-soho-01(config)#interface Serial 0
maui-soho-01(config-if)#ip add 10.0.0.1 255.255.255.0
maui-soho-01(config-if)#encapsulation ppp
maui-soho-01(config-if)#no shutdown

If your platform supports async, then use the physical-layer async command for async mode. Such an application is useful to connect an external modem to the router. Refer to the document 2 Port Async/Sync WAN Interface Card (WIC-2A/S) for an example