redis 安全模式 访问失败

2019独角兽企业重金招聘Python工程师标准>>>

Redis::sAdd(): send of 45 bytes failed with errno=32 Broken pipe
Redis::set(): send of 8192 bytes failed with errno=104 Connection reset by peer

......

首先确定redis服务已经开启，如果还报错

因为reids服务器端，设置的IP主机地址，比如内网地址192.168.1.123，reids 升级版本之后，因为安全模式，导致访问失败

解决办法

1.    登录到redis客户端，然后关闭安全模式，

CONFIG SET protected-mode no

2.    配置信息 主机地址，写127.0.0.1或localhost

 

 

 

在redis3.2之后，redis增加了protected-mode，在这个模式下，即使注释掉了bind 127.0.0.1，再访问redisd时候还是报错，如下

(error) DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.

 

参考博文

http://www.cnblogs.com/liusxg/p/5712493.html

转载于:https://my.oschina.net/osgrace/blog/881155