解决Couldn't resolve host 'mirrorlist.centos.org

这个错误引起主要是因为环境读取不到yun引起的可以考虑/etc/sysconfig/network-scripts/ifcfg-eth0 配置出错导致网络不通。或者/etc/resolv.conf的DNS配置出错。或者可以考虑清楚yum缓存影响（yum clean all）

vi /etc/resolv.conf

nameserver 202.106.0.20（今天又出现此错误，这个nameserver加进去就好了。记得配置静态ip的话DNS也需要加入 然后update yum试试成功就OK了）

 

（下面是网上找到比较有用资料）

今天在linux环境通过yum安装软件报了以下错误：

[root@multi-mysql yum.repos.d] # yum install ncurses devel -y Loaded plugins: fastestmirror, security Loading mirror speeds from cached hostfile Could not retrieve mirrorlist http: //mirrorlist .centos.org/?release=6&arch=x86_64&repo=os error was 14: PYCURL ERROR 6 -  "Couldn't resolve host 'mirrorlist.centos.org'" Error: Cannot  find  a valid baseurl  for  repo: base

从字面意义上看是不能解析mirrorlist.centos.org这个地址，应该是跟dns网络配置有关系，最后解决方法是在DNS域名解析的配置文件增加DNS服务器的IP地址：

[root@multi-mysql ~] # vim /etc/resolv.conf nameserver 8.8.8.8 nameserver 202.106.0.20

重启网络服务

[root@multi-mysql ~] # /etc/init.d/network restart Shutting down interface eth0:                              [  OK  ] Shutting down loopback interface:                          [  OK  ] Bringing up loopback interface:                            [  OK  ] Bringing up interface eth0:  Determining  if  ip address 192.168.1.202 is already  in  use  for  device eth0...                                                             [  OK  ]

重新yum安装，正常

[root@multi-mysql ~] # yum install nmap -y Loaded plugins: fastestmirror, security Loading mirror speeds from cached hostfile   * base: mirrors.yun-idc.com   * extras: mirrors.yun-idc.com   * updates: mirrors.yun-idc.com base                                                                                                         | 3.7 kB     00:00      base /primary_db                                                                                               | 4.6 MB     00:01      extras                                                                                                       | 3.4 kB     00:00      extras /primary_db                                                                                             |  33 kB     00:00      updates                                                                                                      | 3.4 kB     00:00      updates /primary_db                                                                                            | 2.6 MB     00:00      Setting up Install Process Resolving Dependencies --> Running transaction check ---> Package nmap.x86_64 2:5.51-4.el6 will be installed --> Finished Dependency Resolution ......此处省略

转载于:https://www.cnblogs.com/yaohaitao/p/5361639.html