从休眠模式(Power-off)唤醒过程

1.一旦某个唤醒源有信号进来，内部的复位信号will be asserted；This reset duration由内部的16-bit 计数器逻辑决定，the reset assertion time由tRST = (65535 /XTAL_frequency)计算得来。

问题：reset duration和the reset assertion time表示什么？？有什么区别？？

 

2.检查GSTATUS2[2],看上电是否是由休眠模式唤醒而引起的；

ldr r1, = GSTATUS2 ; Determine Booting Mode
ldr r10, [r1]
tst r10, # 0x2
beq % F2 ; if not wakeup from PowerOffmode Skip
; MISCCR setting

三种复位模式：Power on reset，Power_OFF reset，Watchdog reset.对应于GSTATUS2[0~2]

 

3，通过设置MISCCR[19:17]位为000b来释放SDRAM信号保护

ldr r1, = MISCCR ; MISCCR ' s Bit 17, 18, 19 -> 0
ldr r0, [r1] ; I don ' t know why, Just fallow Sample Code.
bic r0, r0, #( 7 << 17 ) ; SCLK0: 0 -> SCLK, SCLK1: 0 -> SCLK, SCKE:L -> H
str r0, [r1]

 

 

4，配置SDRAM内存控制器

; Set memory control registers
add r0, pc, #SMRDATA - (. + 8 )
ldr r1, = BWSCON ; BWSCON Address
add r2, r0, # 52 ; End address of SMRDATA
loop10
ldr r3, [r0], # 4
str r3, [r1], # 4
cmp r2, r0
bne loop10

S3c2410共有13个存储控制寄存器，每个寄存器占4个字节，共52个字节

 

5，等待SDRAM的自刷新被释放

mov r1, # 256
loop11
subs r1, r1, # 1 ; wait until the SelfRefresh is released.
bne loop11

 

6，用户可以根据自己的目的来使用GSTATUS3,4，因为在休眠模式GSTATUS3,4中的值被保留

 

7. – For EINT[3:0], check the SRCPND register.
    – For EINT[15:4], check the EINTPEND instead of SRCPND (SRCPND will not be set although some bits of
EINTPEND are set.).
    – For alarm wake-up, check the RTC time because the RTC bit of SRCPND isn’t set at the alarm wake-up.
    – If there was the nBATT_FLT assertion during POWER_OFF mode, the corresponding bit of SRCPND has
been set.

 

 

 

 

转载于:https://www.cnblogs.com/EmbeddedBoy/archive/2010/04/30/1725128.html