CCNA(Stand-ALONE)Lab 22-Introduction to the Switch

Objective: View some basic areas of a Cisco Catalyst 1900 switch.
Lab Equipment: Switch 1 from the eSwitches menu
Background Reading: Lab Primer Lesson 11: Switches
1. Connect to Switch 1. You should see the user mode prompt.
>

2. Enter the command to display the IOS version of the switch.
>show version
What version of the IOS is running? _______________________
What is the model number of the switch? ___________________
What is the Base Ethernet Address of the switch? _____________

3. Display the interfaces of the switch.
>show interfaces
How many of the interfaces are 10 Mbps? ___________________
How many ports are 100 Mbps Fast Ethernet? ________________

4. Enter the command to view the MAC address table.
>show mac-address-table
How many dynamic entries have been learned? _______________

5. Display the running configuration.
#show running-config 

*****************************************************************

Above:CCNA(Stand-ALONE)Lab 21-ISDN

Next:CCNA(Stand-ALONE)Lab 23-Introduction to Basic Switch Commands

本文转自redking51CTO博客，原文链接：http://blog.51cto.com/redking/72490 ，如需转载请自行联系原作者