CISCO ASA5505做transparent模式稍微特殊一点：ASA5505的接口不能配置成路由口，只能用SVI接口，没有加license时，只能允许配置2个vlan。

        下面是cisco官网上防火墙配置成透明模式的要求：

1.版本要求：

  • PIX Security Appliance with 7.x and later
  • ASA with version 7.x and later

2.Follow these guidelines when you plan your transparent firewall network:

  • A management IP address is required; for multiple context mode, an IP address is required for each context.

         Unlike routed mode, which requires an IP address for each interface, a transparent firewall has an IPaddress assigned to the entire device. The security appliance uses this IP address as the source addressfor packets that originate on the security appliance, such as system messages or AAA communications

         The management IP address must be on the same subnet as the connected network. You cannot set the subnet to a host subnet (255.255.255.255).

  • The transparent security appliance uses an inside interface and an outside interface only. If your platform includes a dedicated management interface, you can also configure the management interface or subinterface for management traffic only.
     

         In single mode, you can only use two data interfaces (and the dedicated management interface, if available) even if your security appliance includes more than two interfaces.

  • Each directly connected network must be on the same subnet.
  • Do not specify the security appliance management IP address as the default gateway for connected devices; devices need to specify the router on the other side of the security appliance as the default gateway.
  • For multiple context mode, each context must use different interfaces; you cannot share an interface across contexts.
  • For multiple context mode, each context typically uses a different subnet. You can use subnets that overlap, but your network topology requires router and NAT configuration to make it possible from a routing standpoint.
  • You must use an extended access list to allow Layer 3 traffic, such as IP traffic, through the security appliance.

          You can also optionally use an EtherType access list to allow non−IP traffic through.

 

 

ASA5505透明模式下完全配置    Version 7.2(3)      （7.2版本配置来源于网络）

ciscoasa# show run
: Saved
:
ASA Version 7.2(3)
!
firewall transparent
hostname ciscoasa
domain-name default.domain.invalid
enable password 8Ry2YjIyt7RRXU24 encrypted
names
!
interface Vlan1
nameif inside
security-level 100
!
interface Vlan2
nameif outside
security-level 0
!
interface Ethernet0/0
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
switchport access vlan 2
!
interface Ethernet0/5
switchport access vlan 2
!
interface Ethernet0/6
!
interface Ethernet0/7
!
passwd 2KFQnbNIdI.2KYOU encrypted
ftp mode passive
dns server-group DefaultDNS
domain-name default.domain.invalid
access-list 111 extended permit tcp any any eq ftp-data
access-list 111 extended permit tcp any any eq ssh
access-list 111 extended permit tcp any any eq www
access-list 111 extended permit tcp any any eq 8080
access-list 111 extended permit tcp any any eq 6600
access-list 111 extended permit tcp any any eq 7877
access-list 111 extended permit tcp any any range 2020 2121
access-list 111 extended permit tcp any any range 6800 6900
access-list 111 extended permit tcp any any range 5200 5400
access-list 111 extended permit icmp any any
pager lines 24
mtu inside 1500
mtu outside 1500
ip address 192.168.100.100 255.255.255.0
icmp unreachable rate-limit 1 burst-size 1
asdm p_w_picpath disk0:/asdm-523.bin
no asdm history enable
arp timeout 14400
access-group 111 in interface outside
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout uauth 0:05:00 absolute
http server enable
http 0.0.0.0 0.0.0.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
telnet 0.0.0.0 0.0.0.0 inside
telnet timeout 5
ssh timeout 5
console timeout 0
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
!
service-policy global_policy global
prompt hostname context
Cryptochecksum:871ee08b54631ff021ad0c4a1a3db59d
: end
ciscoasa#
 *************7.2版本，5505配置管理IP的命令式#ip address  ip**************
 

 ASA5505透明模式下完全配置    Version 8.4(3) （8.4版本是近期工作中的配置）
       
ciscoasa# show run
: Saved
:
ASA Version 8.4(3)
!
firewall transparent
hostname ciscoasa
enable password 2KFQnbNIdI.2KYOU encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
!
interface Ethernet0/0
 description outside
 switchport access vlan 2
!
interface Ethernet0/1
 description inside
!
interface Ethernet0/2
 shutdown
!
interface Ethernet0/3
 shutdown
!
interface Ethernet0/4
 shutdown
!            
interface Ethernet0/5
 shutdown
!
interface Ethernet0/6
 shutdown
!
interface Ethernet0/7
 shutdown
!
interface Vlan1
 nameif inside
 bridge-group 1
 security-level 100
!
interface Vlan2
 nameif outside
 bridge-group 1
 security-level 0
!
interface BVI1
 ip address 172.16.5.140 255.255.255.0
!
ftp mode passive
access-list 100 extended permit ip 172.16.0.0 255.255.255.0 any
access-list 100 extended permit tcp 172.16.0.0 255.255.255.0 any
access-list 100 extended permit udp 172.16.0.0 255.255.255.0 any
pager lines 24
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
access-group 100 in interface outside
timeout xlate 3:00:00
timeout pat-xlate 0:00:30
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart warmstart
telnet timeout 5
ssh timeout 5
console timeout 0
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
!
class-map inspection_default
 match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
 parameters
  message-length maximum client auto
  message-length maximum 512
policy-map global_policy
 class inspection_default
  inspect dns preset_dns_map
  inspect ftp
  inspect h323 h225
  inspect h323 ras
  inspect rsh
  inspect rtsp
  inspect esmtp
  inspect sqlnet
  inspect skinny 
  inspect sunrpc
  inspect xdmcp
  inspect sip 
  inspect netbios
  inspect tftp
  inspect ip-options
!
service-policy global_policy global
prompt hostname context
Cryptochecksum:25ff7651711142ae22159248f08f3d97
: end
ciscoasa#  wr
Building configuration...
Cryptochecksum: 25ff7651 711142ae 22159248 f08f3d97

2488 bytes copied in 1.20 secs (2488 bytes/sec)
[OK]
*************8.4版本，5505配置管理IP的命令式没有#ip address  ip这条命令，需要引入桥接IP，然后将vlan加到这个BVI组里面************