配置VLAN,VTP,及交换机的端口安全性
2、理解VTP的工作原理,会配置VTP。 3、会配置交换机的端口安全性。 实验设备:CISCO2950交换机三台,PC两台,网线若干。 实验内容: 1、按上图将交换机和PC连接好。 Sw1 port1 ~ sw2 port1 Sw1 port2 ~ sw3 port1 Sw2 port2 ~ sw3 port2 PC1 ~sw1 port 3 PC2 ~sw3 port 3 将三台交换机分别命名为SW1、SW2、SW3。Pc1:ip—192.168.1.4/24 Pc2:ip—192.168.3.5/24 2、查看端口转发模式: Switch#show port system 3、将交换机间互联的端口模式设置为trunk. 语法为:switch(config-if)#switchport mode trunk 4、配置三台交换机的console 和vty密码为cisco. 5、配置vtp域名为founder,sw1 的模式为server,sw2和sw3的模式为client.配置修剪。 语法为:switch#vlan database Switch(vlan)#vtp domain domain-name Switch(vlan)#vtp client|transparent|server Switch(vlan)#vtp pruning 6、在SW1上配置vlan2,vlan3。并将Sw1的Port3~port10加入Vlan2。 语法为:switch(config-if)#switchport mode access Switch(config-if)#swtichport access vlan number 将SW3上的port3~port5加入Vlan3。 7、设置vlan 管理ip及网关 :vlan1—192.168.2.2/24,网关:192.168.2.1 语法为:switch(config)#interface vlan number Switch(config-if)#ip address ip netmask Switch(config-if)#no shutdown Switch(config)#ip default-gateway ipaddress 8、验证配置。 Switch#Show vtp status Swtich#Show vlan 9、配置端口安全性。设置Sw1的port3端口最大MAC地址数为50。 限制Sw1上的port三端口的Pc1 的mac地址只有port1,port2可以访问。设置sw3上的port3端口为保护的。 配置语法: Switch(config-if)#switchport port-security maxmum number Switch(config)# mac-address-table restricted static {mac-address type module/port src-if-list} 例如:switch(config)#mac-address-table restricted static 002d.0124.0254 f0/1 f0/2 //限制f0/1端口的mac 002d.0124.0254只有f0/2端口可以访问。 Switch(config-if)#switchport port-security violation protect|restrict|shutdown 10、 启动http访问 语法:switch(config)#ip http server//启动http访问 Switch(config)#ip http port number //指定端口 |
转载于:https://blog.51cto.com/hypc123/364969