RTL8188CUS

2019独角兽企业重金招聘Python工程师标准>>>

Single-Chip IEEE 802.11b/g/n 1T1R WLAN Controller with USB2.0 Interface (QFN-46)

General Description

The Realtek RTL8188CUS-GR is a highly integrated single-chip QFN-46 pin Wireless LAN (WLAN) USB2.0 network interface controller compatible with the 802.11n specification. It combines a MAC, a 1T1R capable baseband, and RF in a single chip. The RTL8188CUS provides a complete solution for a high throughput performance wireless client. The RTL8188CUS baseband implements Orthogonal Frequency Division Multiplexing (OFDM) with 1 transmit and 1 receive path and is compatible with the IEEE 802.11n specification. Features include one spatial stream transmission, short guard interval (GI) of 400ns, spatial spreading, and transmission over 20MHz and 40MHz bandwidth. For legacy compatibility, Direct Sequence Spread Spectrum (DSSS), Complementary Code Keying (CCK) and OFDM baseband processing are included to support all IEEE 802.11b and 802.11g data rates. Differential phase shift keying modulation schemes, DBPSK and DQPSK with data scrambling capability, are available, and CCK provides support for legacy data rates, with long or short preamble.  The high-speed FFT/IFFT paths, combined with BPSK, QPSK, 16QAM, and 64QAM modulation of the individual subcarriers and rate compatible punctured convolutional coding with coding rate of 1/2, 2/3, 3/4, and 5/6, provide higher data rates of 54Mbps and 150Mbps for IEEE 802.11g and 802.11n OFDM respectively. The RTL8188CUS builds in an enhanced signal detector, an adaptive frequency domain equalizer, and a soft-decision Viterbi decoder to alleviate severe multi-path effects and mutual interference in the reception of multiple streams. Robust interference detection and suppression are provided to protect against Bluetooth, cordless phone, and microwave oven interference. Efficient IQ-imbalance, DC offset, phase noise, frequency offset, and timing offset compensations are provided for the radio frequency front-end. Selectable digital transmit and receive FIR filters are provided to meet transmit spectrum mask requirements and to reject adjacent channel interference, respectively. The RTL8188CUS supports fast receiver Automatic Gain Control (AGC) with synchronous and asynchronous control loops among antennas, antenna diversity functions, and adaptive transmit power control function to obtain the better performance in the analog portions of the transceiver. The RTL8188CUS MAC supports 802.11e for multimedia applications, 802.11i for security, and 802.11n for enhanced MAC protocol efficiency. Using packet aggregation techniques such as A-MPDU with BA and A-MSDU, protocol efficiency is significantly improved. Power saving mechanisms such as Legacy Power Save, and U-APSD, and APSD, reduce the power wasted during idle time, and compensates for the extra power required to transmit OFDM. The RTL8188CUS provides simple legacy and 20MHz/40MHz co-existence mechanisms to ensure backward and network compatibility.

Features

General 46-pin QFN CMOS MAC, Baseband PHY, and RF in a single chip for IEEE 802.11b/g/n compatible WLAN Complete 802.11n solution for 2.4GHz band 72.2Mbps receive PHY rate and 72.2Mbps transmit PHY rate using 20MHz bandwidth 150Mbps receive PHY rate and 150Mbps transmit PHY rate using 40MHz bandwidth Compatible with 802.11n specification Backward compatible with 802.11b/g devices while operating in 802.11n mode Host Interface Complies with USB Specification Revision 2.0 Standards Supported IEEE 802.11b/g/n compatible WLAN IEEE 802.11e QoS Enhancement (WMM) IEEE 802.11h TPC, Spectrum Measurement 802.11i (WPA, WPA2). Open, shared key, and pair-wise key authentication services MAC Features Frame aggregation for increased MAC efficiency (A-MSDU, A-MPDU) Low latency immediate High-Throughput Block Acknowledgement (HT-BA) Long NAV for media reservation with CF-End for NAV release PHY-level spoofing to enhance legacy compatibility Power saving mechanism Channel management and co-existence Multiple BSSID feature allows the RTL8188CUS to assume multiple MAC identities when used as a wireless bridge Transmit Opportunity (TXOP) Short Inter-Frame Space (SIFS) bursting for higher multimedia bandwidth Peripheral Interfaces General Purpose Input/Output (10 pins) Three configurable LED pins Configurable Bluetooth Coexistence Interface PHY Features IEEE 802.11n OFDM One Transmit and one Receive path (1T1R) 20MHz and 40MHz bandwidth transmission Short Guard Interval (400ns) DSSS with DBPSK and DQPSK, CCK modulation with long and short preamble OFDM with BPSK, QPSK, 16QAM, and 64QAM modulation. Convolutional Coding Rate: 1/2, 2/3, 3/4, and 5/6 Maximum data rate 54Mbps in 802.11g and 150Mbps in 802.11n Switch diversity for DSSS/CCK Hardware antenna diversity Selectable receiver FIR filters Programmable scaling in transmitter and receiver to trade quantization noise against increased probability of clipping Fast receiver Automatic Gain Control (AGC) On-chip ADC and DAC

Applications

Single-Band 11n (1x1) WLAN USB Dongle Single-Band 11n (1x1) WLAN USB Module Single-Band 11n (1x1) WLAN with Bluetooth 3.0+HS USB Combo MiniCard

转载于:https://my.oschina.net/u/1024767/blog/176374