拓扑图

clip_image002

实验配置 CPE上的配置

clip_image004

1，在端口上配置inside和outside

配置fastEthernet0/1为ip nat inside

Router#conf t

Router(config)#interface f 0/1

Router(config-if)#ip nat inside

配置serial 0/0为ip nat inside

Router(config)#interface serial 0/0

Router(config-if)#ip nat outside

2，在全局上配置NAT

配置只转换10.1.1.1的ACL，并且在NAT中的source应用

Inside Global 地址是serial 0/0的接口地址

Router(config)#access-list 1 permit 10.1.1.1 0.0.0.0

Router(config)#ip nat inside source list 1 interface serial 0/0

3，在全局上配置默认路由

Router(config)#ip route 0.0.0.0 0.0.0.0 serial 0/0

4，保存配置

Router#copy run st

实验验证

Debug信息

NAT: s=10.1.1.1->172.16.12.10, d=172.16.23.1 [11]

NAT*: s=172.16.23.1, d=172.16.12.10->10.1.1.1 [9]

show ip nat statistics

Total translations: 1 (0 static, 1 dynamic, 1 extended)

Outside Interfaces: Serial0/0

Inside Interfaces: FastEthernet0/1

Hits: 2 Misses: 18

Expired translations: 1

Dynamic mappings:

show ip nat translations

Pro Inside global Inside local Outside local Outside global

icmp 172.16.12.10:11 10.1.1.1:11 172.16.23.1:11 172.16.23.1:11