MicroPython的TPYBoard驱动LCD5110

2019独角兽企业重金招聘Python工程师标准>>>

    MicroPython的TPYBoard驱动LCD5110，

    先看一下LCD5110针脚含义吧（注意：LCD5110的针脚有些不一样的）

    TPYBoard的针脚与5110的针脚对应关系如下：

    TPYBoard       LCD5110    memo
    ————————————————————————————
    # any   Pin        => RST       Reset pin (0=reset, 1=normal)
    # any   Pin        => CE        Chip Enable (0=listen for input,   1=ignore input)
    # any   Pin        => DC        Data/Command (0=commands, 1=data)
    #   MOSI          => DIN       data flow (Master out, Slave in)
    #   SCK           => CLK       SPI clock
    # 3V3   or any Pin  => VCC       3.3V logic voltage (0=off, 1=on)
    # any   Pin        => LIGHT     Light (0=on, 1=off)

    #   GND           => GND

    还是看不明白的话，直接上针脚编号吧

    TPYBoard       LCD5110    memo
    ————————————————————————————
    Y10        => RST       Reset pin (0=reset, 1=normal)
    Y11        => CE        Chip Enable (0=listen for input, 1=ignore input)
    Y9         => DC        Data/Command (0=commands, 1=data)
    X8         => DIN       data flow (Master out, Slave in)
    X6         => CLK       SPI clock
    VCC
    Y12        => LIGHT     Light (0=on, 1=off)

    GND

    接线ok后，可运行main.py了。

    main.py源代码：

import pyb
import upcd8544
from machine import SPI,Pin
  
def main():
    SPI    = pyb.SPI(1) #DIN=>X8-MOSI/CLK=>X6-SCK
    #DIN =>SPI(1).MOSI 'X8' data flow (Master out, Slave in)
    #CLK =>SPI(1).SCK  'X6' SPI clock
    
    RST    = pyb.Pin('Y10')
    CE     = pyb.Pin('Y11')
    DC     = pyb.Pin('Y9')
    LIGHT  = pyb.Pin('Y12')
    lcd_5110 = upcd8544.PCD8544(SPI, RST, CE, DC, LIGHT)
    
    lcd_5110.lcd_write_string('Hello Python!',0,0)
    lcd_5110.lcd_write_string('Micropython',6,1)
    lcd_5110.lcd_write_string('TPYBoard',12,2)
    lcd_5110.lcd_write_string('v102',60,3)
    lcd_5110.lcd_write_string('This is a test of LCD5110',0,4)
    
  
if __name__ == '__main__':
main()

 

转载于:https://my.oschina.net/micropython/blog/726490