1>》在R1和R2上分别开启OSPF进程

2》在R1上配置认证密码
      R1(config-if)#ip ospf authentication-key cisco
3》在R2上配置认证密码
      R2(config-if)#ip ospf authentication-key cisco
4》实验调试
◆R1#show ip ospf interface s0/3/0
Serial0/3/0 is up, line protocol is up
  Internet address is 192.168.12.1/24, Area 0
  Process ID 1, Router ID 1.1.1.1, Network Type POINT-TO-POINT, Cost: 781
  Transmit Delay is 1 sec, State POINT-TO-POINT, Priority 0
  No designated router on this network
  No backup designated router on this network
  Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
    Hello due in 00:00:04
  Index 2/2, flood queue length 0
  Next 0x0(0)/0x0(0)
  Last flood scan length is 1, maximum is 1
  Last flood scan time is 0 msec, maximum is 0 msec
  Neighbor Count is 1 , Adjacent neighbor count is 1
    Adjacent with neighbor 2.2.2.2
  Suppress hello for 0 neighbor(s)
  Simple password authentication enabled   这一行信息表明该接口启用了简单口令认证。
◆R1#show ip ospf
 Routing Process "ospf 1" with ID 1.1.1.1
 Supports only single TOS(TOS0) routes
 Supports opaque LSA
 SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
 Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs
 Number of external LSA 0. Checksum Sum 0x000000
 Number of opaque AS LSA 0. Checksum Sum 0x000000
 Number of DCbitless external and opaque AS LSA 0
 Number of DoNotAge external and opaque AS LSA 0
 Number of areas in this router is 1. 1 normal 0 stub 0 nssa
 External flood list length 0
    Area BACKBONE(0)
        Number of interfaces in this area is 2
        Area has simple password authentication 这一行表明区域0采用了简单口令认证。
        SPF algorithm executed 2 times
        Area ranges are
        Number of LSA 2. Checksum Sum 0x00dc42
        Number of opaque link LSA 0. Checksum Sum 0x000000
        Number of DCbitless LSA 0
        Number of indication LSA 0
        Number of DoNotAge LSA 0
        Flood list length 0 

注意：如果一边开启了简单口令认证一边没有则在此区域，OSPF协议不能正常工作，或者两边密码不一致也是一样的，这个大家可以进行简单的验证。

       谢谢大家！！