万一灌错了固件的版本,或者是文件本身已顺坏造成AP无法正常启动,可以按照以下步骤恢复:
Step 1
The PC on which your TFTP server software runs must be configured with a static IP address in the range of 10.0.0.2 to 10.0.0.30.
Step 2
Make sure that the PC contains the access point p_w_picpath file (such as c1200-k9w7-tar.122-15.JA.tar for a 1200 series access point) in the TFTP server folder and that the TFTP server is activated.
Step 3
Rename the access point p_w_picpath file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point.
Step 4
Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.
Step 5
Disconnect power from the access point.
Step 6
Press and hold the MODE button while you reconnect power to the access point.
Step 7
Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds), and release the MODE button.
Step 8
Wait until the access point reboots as indicated by all LEDs turning green followed by the Status LED blinking green.
Step 9
After the access point reboots, reconfigure the access point using the GUI or the CLI.
转载于:https://blog.51cto.com/jackiechen/221619