VMware ESXi step-by-step Installation Guide wit...

2019独角兽企业重金招聘Python工程师标准>>>

As part of the on-going VMware article series, earlier we discussed about VMware virtualization fundamentals, and how to install VMware Server 2.

In this article, let us discuss about how to install VMware ESXi.

VMware ESXi is free. However, the software comes with a 60 days evaluation mode. You should register on VMware website to get your free license key to come out of the evaluation mode. Once the ESXi is installed, you can either user vSphere Client on the Direct Console User Interface to administer the host.

VMware ESXi is based on hypervisor architecture that runs directly on top of a hardware as shown below.

1. Download ESXi server

Get the software from the VMware ESXi download page.

Following are the various download options available. Select “ESXi 4.0 Update 1 Installable (CD ISO) Binary (.iso)” and burn a CD.

• ESXi 4.0 Update 1 Installable (CD ISO)
• Upgrade package from ESXi Server 3.5 to ESXi Server 4.0 Update 1
• Upgrade package from ESXi Server 4.0 to ESXi Server 4.0 Update 1
• VMware vSphere Client and Host Update Utility

2. VMware VMvisor Boot Menu

Once you insert the ESXi CD and reboot the server, it will display a boot menu with an option to launch “ESXi Installer” as shown below.

3. VMware ESXi Installer Loading

While the installer is loading all the necessary modules, it will display the server configuration information at the top as shown below. In this example, I was installing VMware ESXi 4.0 on a Dell PowerEdge 2950 server.

4. New ESXi Install

Since this is a new installation of ESXi, select “Install” in the following screen.

5. Accept VMware EULA

Read and accept the EULA by pressing F11.

6. Select a Disk to Install VMware ESXi

VMware ESXi 4.0.0 Installer will display all available disk groups. Choose the Disk where you would like to install the ESXi. It is recommended to choose the Disk0.

7. Confirm ESXi Installation

Confirm that you are ready to start the install process.

8. Installation in Progress

The installation process takes few minutes. While the ESXi is getting installed, it will display a progress bar as shown below.

9. ESXi Installation Complete

You will get the following installation completed message that will prompt you to reboot the server.

10. ESXi Initial Screen

After the ESXi is installed, you’ll get the following screen where you can configure the system by pressing F2.

In the next article, let us review how to perform the initial ESXi configuration.

转载于:https://my.oschina.net/u/238880/blog/76905