zybo上运行linux,嵌入式Linux教程 - Zybo （上）

This Embedded Linux hands-on tutorial for the Zybo will provide step-by-step instructions for customizing your hardware, compiling the Linux Kernel and writing driver and user applications. This documentation intends to integrate knowledge and skills in FPGA logic circuit design, standalone software programming, and Linux operating system and software development, and apply them to the Zybo.

In this tutorial, we will start from the Zybo Base System Design (available on the Zybo product page of the Digilent website). The system architecture for the Zybo Base System Design is shown in the first picture in this step.

In the Zybo Base System Design, we connect UART1 to USB-UART, SD0 to the SD Card Slot, USB0 to the USB-OTG port, Enet0 to the Giga-bit Ethernet Port, and Quad SPI to the on-board QSPI Flash. These cores are hard IPs inside the Processing System (PS) and connect to on-board peripherals via Multiplexed I/O (MIO) pins. The use of PS GPIO is is connected to BTNs 4 and 5. In the Programmable Logic (PL), we have an HDMI Tx Controller, VDMA, and GPIO IP cores to talk to the ADV7511 HDMI Transmitter Chip and I2S and GPIO IP Cores for ADAU1761 Audio Codec. More details of the hardware design can be found in the documentation inside the Zybo Base System Design package.

Before going through this tutorial, we recommend that you read Getting Started with Embedded Linux -- ZedBoard first. You can follow this tutorial with the Embedded Linux Development Guide (available on the Digilent Website Embedded Linux Page). The guide will provide you with the knowledge you may need in each step of the development.

In this tutorial, we are going to use Vivado 2014.1 Webpack in a Linux environment. All the screen shots and codes are done using Vivado Design Suite2014.1 in Fedora 19 x86_64.

Required Materials:

- Pre-built File System Image (available in the Zybo Linux Reference Design)

*Note: Use the Master-Next Branches until further notice

That’s it for the background information on this tutorial, now it’s time to get our hands dirty with some real design!