无线控制模块c语言编程,51单片机对无线模块nRF24L01简单的控制收发程序

它的一些物理特性如工作频段、供电电压、数据传输速率就不详细介绍了，直接上代码。

1.首先是发送端：

// Define SPI pins

#include #define uchar unsigned char

/***************************************************/

#define TX_ADR_WIDTH 5 // 5字节宽度的发送/接收地址

#define TX_PLOAD_WIDTH 4 // 数据通道有效数据宽度

sbit LED = P2^1;

sbit KEY1 = P3^1;

sbit KEY2 = P3^2;

uchar code TX_ADDRESS[TX_ADR_WIDTH] = {0x34,0x43,0x10,0x10,0x01}; // 定义一个静态发送地址

uchar RX_BUF[TX_PLOAD_WIDTH];

uchar TX_BUF[TX_PLOAD_WIDTH];

uchar flag;

uchar DATA = 0x01;

uchar bdata sta;

sbit RX_DR = sta^6;

sbit TX_DS = sta^5;

sbit MAX_RT = sta^4;

sbit CE = P1^5;

sbit CSN= P1^4;

sbit SCK= P1^3;

sbit MOSI= P1^2;

sbit MISO= P1^1;

sbit IRQ = P1^0;

// SPI(nRF24L01) commands

#define READ_REG 0x00 // Define read command to register

#define WRITE_REG 0x20 // Define write command to register

#define RD_RX_PLOAD 0x61 // Define RX payload register address

#define WR_TX_PLOAD 0xA0 // Define TX payload register address

#define FLUSH_TX 0xE1 // Define flush TX register command

#define FLUSH_RX 0xE2 // Define flush RX register command

#define REUSE_TX_PL 0xE3 // Define reuse TX payload register command

#define NOP 0xFF // Define No Operation, might be used to read status register

// SPI(nRF24L01) registers(addresses)

#define CONFIG 0x00 // 'Config' register address

#define EN_AA 0x01 // 'Enable Auto Acknowledgment' register address

#define EN_RXADDR 0x02 // 'Enabled RX add